On Wed, 2014-11-05 at 13:09 +0000, Jonathan Cameron wrote:
> On 03/11/14 15:24, Ivan T. Ivanov wrote:
> > From: Stanimir Varbanov <svarbanov@xxxxxxxxxx>
> >
> > The voltage ADC is peripheral of Qualcomm SPMI PMIC chips. It has
> > 15 bits resolution and register space inside PMIC accessible across
> > SPMI bus.
> >
> > The vadc driver registers itself through IIO interface.
> >
> > Signed-off-by: Stanimir Varbanov <svarbanov@xxxxxxxxxx>
> > Signed-off-by: Ivan T. Ivanov <iivanov@xxxxxxxxxx>
> Hi Ivan,
>
> Couple of utterly tiny bits inline. The biggest one is that
> you store some info about the calibration that you never actually
> use... Left over from some debugging perhaps?
>
> Jonathan
<snip>
> > +
> > +/*
> > + * VADC_CALIB_ABSOLUTE: uses the 625mV and 1.25V as reference channels.
> > + * VADC_CALIB_RATIOMETRIC: uses the reference voltage (1.8V) and GND for
> > + * calibration.
> > + */
> > +enum vadc_calibration {
> > + VADC_CALIB_ABSOLUTE = 0,
> > + VADC_CALIB_RATIOMETRIC
> > +};
> > +
> > +/**
> > + * struct vadc_linear_graph - Represent ADC characteristics.
> > + * @dy: numerator slope to calculate the gain.
> As dy is always equal to vref-gnd you could drop it and use those
> directly...
>
> Conversly you store vref or grnd and never use them...
I am not sure I am following you. Please take a look in
vadc_measure_ref_points() and vadc_calibrate().
>
> > + * @dx: denominator slope to calculate the gain.
> > + * @vref: A/D word of the voltage reference used for the channel.
> > + * @gnd: A/D word of the ground reference used for the channel.
> > + *
> > + * Each ADC device has different offset and gain parameters which are
> > + * computed to calibrate the device.
> > + */
> > +struct vadc_linear_graph {
> > + s32 dy;
> > + s32 dx;
> > + s32 vref;
> > + s32 gnd;
> > +};
> > +
> >
Will address blank line comment.
Regards,
Ivan
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
