Use the same USB definition as qcom-apq8064.dtsi, tested on Casio GzOne.
Signed-off-by: Shinjo Park <peremen@xxxxxxxxx>
Reviewed-by: David Heidelberg <david@xxxxxxx>
---
v3:
- Include missing clock/qcom,lcc-msm8960.h to make cleanly applicable
v2:
- Rewrite commit message
- Reorder status line
arch/arm/boot/dts/qcom-msm8960.dtsi | 33 +++++++++++++++++++++++++++++
1 file changed, 33 insertions(+)
diff --git a/arch/arm/boot/dts/qcom-msm8960.dtsi b/arch/arm/boot/dts/qcom-msm8960.dtsi
index e14e1c5d1..0e099aa7c 100644
--- a/arch/arm/boot/dts/qcom-msm8960.dtsi
+++ b/arch/arm/boot/dts/qcom-msm8960.dtsi
@@ -3,6 +3,8 @@
#include <dt-bindings/interrupt-controller/arm-gic.h>
#include <dt-bindings/clock/qcom,gcc-msm8960.h>
+#include <dt-bindings/clock/qcom,lcc-msm8960.h>
+#include <dt-bindings/reset/qcom,gcc-msm8960.h>
#include <dt-bindings/mfd/qcom-rpm.h>
#include <dt-bindings/soc/qcom,gsbi.h>
@@ -167,6 +169,37 @@ regulators {
};
};
+ usb1: usb@12500000 {
+ compatible = "qcom,ci-hdrc";
+ reg = <0x12500000 0x200>,
+ <0x12500200 0x200>;
+ interrupts = <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&gcc USB_HS1_XCVR_CLK>, <&gcc USB_HS1_H_CLK>;
+ clock-names = "core", "iface";
+ assigned-clocks = <&gcc USB_HS1_XCVR_CLK>;
+ assigned-clock-rates = <60000000>;
+ resets = <&gcc USB_HS1_RESET>;
+ reset-names = "core";
+ phy_type = "ulpi";
+ ahb-burst-config = <0>;
+ phys = <&usb_hs1_phy>;
+ phy-names = "usb-phy";
+ #reset-cells = <1>;
+ status = "disabled";
+
+ ulpi {
+ usb_hs1_phy: phy {
+ compatible = "qcom,usb-hs-phy-msm8960",
+ "qcom,usb-hs-phy";
+ clocks = <&sleep_clk>, <&cxo_board>;
+ clock-names = "sleep", "ref";
+ resets = <&usb1 0>;
+ reset-names = "por";
+ #phy-cells = <0>;
+ };
+ };
+ };
+
acc0: clock-controller@2088000 {
compatible = "qcom,kpss-acc-v1";
reg = <0x02088000 0x1000>, <0x02008000 0x1000>;
--
2.34.1
