[PATCH v2 2/4] clk: qcom: clk-rcg2: Make sure to not write d=0 to the NMD register

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Sometimes calculation of d value may result in 0 because of the
rounding after integer division. This causes the following error:

[  113.969689] camss_gp1_clk_src: rcg didn't update its configuration.
[  113.969754] WARNING: CPU: 3 PID: 35 at drivers/clk/qcom/clk-rcg2.c:122 update_config+0xc8/0xdc

Make sure that D value is never zero.

Fixes: 7f891faf596e ("clk: qcom: clk-rcg2: Add support for duty-cycle for RCG")
Signed-off-by: Nikita Travkin <nikita@xxxxxxx>

---
v2:
 - Use clamp()
---
 drivers/clk/qcom/clk-rcg2.c | 9 ++++++---
 1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/drivers/clk/qcom/clk-rcg2.c b/drivers/clk/qcom/clk-rcg2.c
index 2375e8122012..28019edd2a50 100644
--- a/drivers/clk/qcom/clk-rcg2.c
+++ b/drivers/clk/qcom/clk-rcg2.c
@@ -13,6 +13,7 @@
 #include <linux/rational.h>
 #include <linux/regmap.h>
 #include <linux/math64.h>
+#include <linux/minmax.h>
 #include <linux/slab.h>
 
 #include <asm/div64.h>
@@ -461,9 +462,11 @@ static int clk_rcg2_set_duty_cycle(struct clk_hw *hw, struct clk_duty *duty)
 	/* Calculate 2d value */
 	d = DIV_ROUND_CLOSEST(n * duty_per * 2, 100);
 
-	 /* Check bit widths of 2d. If D is too big reduce duty cycle. */
-	if (d > mask)
-		d = mask;
+	/*
+	 * Check bit widths of 2d. If D is too big reduce duty cycle.
+	 * Also make sure it is never zero.
+	 */
+	d = clamp_val(d, 1, mask);
 
 	if ((d / 2) > (n - m))
 		d = (n - m) * 2;
-- 
2.35.3




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux