On 5/13/22 10:57 AM, Kalle Valo wrote:
Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> writes:
Interrupt line can be configured on different hardware in different way,
even inverted. Therefore driver should not enforce specific trigger
type - edge rising - but instead rely on Devicetree to configure it.
All Qualcomm DTSI with WCN3990 define the interrupt type as level high,
so the mismatch between DTSI and driver causes rebind issues:
$ echo 18800000.wifi > /sys/bus/platform/drivers/ath10k_snoc/unbind
$ echo 18800000.wifi > /sys/bus/platform/drivers/ath10k_snoc/bind
[ 44.763114] irq: type mismatch, failed to map hwirq-446 for interrupt-controller@17a00000!
[ 44.763130] ath10k_snoc 18800000.wifi: error -ENXIO: IRQ index 0 not found
[ 44.763140] ath10k_snoc 18800000.wifi: failed to initialize resource: -6
So you tested on WCN3990? On what firmware version? I can add the
Tested-on tag if you provide that.
Hello Krzystof, Kalle,
I have seen this issue as well on a Lenovo Flex 5G, which has a WCN3990:
wcn3990 hw1.0 target 0x00000008 chip_id 0x00000000 sub 0000:0000
kconfig debug 0 debugfs 0 tracing 0 dfs 0 testmode 0
firmware ver api 5 features wowlan,mgmt-tx-by-reference,non-bmi crc32
b3d4b790
htt-ver 3.86 wmi-op 4 htt-op 3 cal file max-sta 32 raw 0 hwcrypto 1
With this patch applied, I no longer see the error message in the commit
message, when I unbind/bind when wifi stops working.
Tested-by: Steev Klimaszewski <steev@xxxxxxxx>
-- Steev
