Re: [PATCH v2] arm64: dts: qcom: db845c: Add support for MCP2517FD

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 19/04/2022 06:33, Vinod Koul wrote:
> Add support for onboard MCP2517FD SPI CAN transceiver attached to
> SPI0 of RB3.
> 
> Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
> ---
> Changes in v2:
>  - add cs and pinctrl config
>  - remove misleading comment
> 
>  arch/arm64/boot/dts/qcom/sdm845-db845c.dts | 33 ++++++++++++++++++++++
>  1 file changed, 33 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/sdm845-db845c.dts b/arch/arm64/boot/dts/qcom/sdm845-db845c.dts
> index 28fe45c5d516..4f4d45be93e3 100644
> --- a/arch/arm64/boot/dts/qcom/sdm845-db845c.dts
> +++ b/arch/arm64/boot/dts/qcom/sdm845-db845c.dts
> @@ -28,6 +28,13 @@ chosen {
>  		stdout-path = "serial0:115200n8";
>  	};
>  
> +	/* Fixed crystal oscillator dedicated to MCP2517FD */
> +	clk40M: can_clock {

No underscores in node names.

> +		compatible = "fixed-clock";
> +		#clock-cells = <0>;
> +		clock-frequency = <40000000>;
> +	};
> +
>  	dc12v: dc12v-regulator {
>  		compatible = "regulator-fixed";
>  		regulator-name = "DC12V";
> @@ -746,6 +753,24 @@ codec {
>  	};
>  };
>  
> +&spi0 {
> +	status = "okay";
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&qup_spi0_default>;
> +	cs-gpios = <&tlmm 3 GPIO_ACTIVE_LOW>;
> +
> +	can@0 {
> +		compatible = "microchip,mcp2517fd";
> +		reg = <0>;
> +		clocks = <&clk40M>;
> +		interrupts-extended = <&tlmm 104 IRQ_TYPE_LEVEL_LOW>;
> +		spi-max-frequency = <10000000>;
> +		vdd-supply = <&vdc_5v>;
> +		xceiver-supply = <&vdc_5v>;
> +		status = "okay";

No need for status for new nodes (unless it is an extension of existing
node?), it is okay by default.


Best regards,
Krzysztof



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux