Hi,
On Wed, Mar 16, 2022 at 6:06 PM Stephen Boyd <swboyd@xxxxxxxxxxxx> wrote:
>
> Having these pins with outputs is good on a fresh boot because it puts
> the boot and reset pins in a known "good" state. Unfortunately, that
> conflicts with the fingerprint firmware flashing code. The firmware
> flashing process binds and unbinds the cros-ec and spidev drivers and
> that reapplies the pin output values after the flashing code has
> overridden the gpio values. This causes a problem because we try to put
> the device into bootloader mode, bind the spidev driver and that
> inadvertently puts it right back into normal boot mode, breaking the
> flashing process.
>
> Fix this by removing the outputs. We'll introduce a binding for
> fingerprint cros-ec specifically to set the gpios properly via gpio APIs
> during cros-ec driver probe instead.
>
> Cc: Douglas Anderson <dianders@xxxxxxxxxxxx>
> Cc: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
> Cc: Alexandru M Stan <amstan@xxxxxxxxxxxx>
> Fixes: 116f7cc43d28 ("arm64: dts: qcom: sc7280: Add herobrine-r1")
> Signed-off-by: Stephen Boyd <swboyd@xxxxxxxxxxxx>
> ---
> arch/arm64/boot/dts/qcom/sc7280-herobrine.dtsi | 2 --
> 1 file changed, 2 deletions(-)
Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
