On Fri, May 30, 2014 at 03:49:50PM -0500, Andy Gross wrote:
> This patch adds support for end of transaction (EOT) and notify when done (NWD)
> hardware descriptor flags.
>
> The EOT flag requests that the peripheral assert an end of transaction interrupt
> when that descriptor is complete. It also results in special signaling protocol
> that is used between the attached peripheral and the core using the DMA
> controller. Clients will specify DMA_PREP_INTERRUPT to enable this flag.
>
> The NWD flag requests that the peripheral wait until the data has been fully
> processed by the peripheral before moving on to the next descriptor. Clients
> will specify DMA_PREP_FENCE to enable this flag.
I am going to apply this, but pls send a follow up patch to add comments on the
flags and their behaviour. I think it is required!
>
> Signed-off-by: Andy Gross <agross@xxxxxxxxxxxxxx>
> ---
> drivers/dma/qcom_bam_dma.c | 20 ++++++++++++++++++--
> 1 file changed, 18 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/dma/qcom_bam_dma.c b/drivers/dma/qcom_bam_dma.c
> index e01c2d106..4635224 100644
> --- a/drivers/dma/qcom_bam_dma.c
> +++ b/drivers/dma/qcom_bam_dma.c
> @@ -61,12 +61,17 @@ struct bam_desc_hw {
> #define DESC_FLAG_INT BIT(15)
> #define DESC_FLAG_EOT BIT(14)
> #define DESC_FLAG_EOB BIT(13)
> +#define DESC_FLAG_NWD BIT(12)
explaining behvaiour will help..
--
~Vinod
>
> struct bam_async_desc {
> struct virt_dma_desc vd;
>
> u32 num_desc;
> u32 xfer_len;
> +
> + /* transaction flags, EOT|EOB|NWD */
> + u16 flags;
> +
> struct bam_desc_hw *curr_desc;
>
> enum dma_transfer_direction dir;
> @@ -490,6 +495,14 @@ static struct dma_async_tx_descriptor *bam_prep_slave_sg(struct dma_chan *chan,
> if (!async_desc)
> goto err_out;
>
> + if (flags & DMA_PREP_FENCE)
> + async_desc->flags |= DESC_FLAG_NWD;
> +
> + if (flags & DMA_PREP_INTERRUPT)
> + async_desc->flags |= DESC_FLAG_EOT;
> + else
> + async_desc->flags |= DESC_FLAG_INT;
> +
> async_desc->num_desc = num_alloc;
> async_desc->curr_desc = async_desc->desc;
> async_desc->dir = direction;
> @@ -795,8 +808,11 @@ static void bam_start_dma(struct bam_chan *bchan)
> else
> async_desc->xfer_len = async_desc->num_desc;
>
> - /* set INT on last descriptor */
> - desc[async_desc->xfer_len - 1].flags |= DESC_FLAG_INT;
> + /* set any special flags on the last descriptor */
> + if (async_desc->num_desc == async_desc->xfer_len)
> + desc[async_desc->xfer_len - 1].flags = async_desc->flags;
> + else
> + desc[async_desc->xfer_len - 1].flags |= DESC_FLAG_INT;
>
> if (bchan->tail + async_desc->xfer_len > MAX_DESCRIPTORS) {
> u32 partial = MAX_DESCRIPTORS - bchan->tail;
> --
> The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
> hosted by The Linux Foundation
>
> --
> To unsubscribe from this list: send the line "unsubscribe dmaengine" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
