From: Tim Bird <tbird20d@xxxxxxxxx> Select the secondary PHY using the TCSR register, if phy-num=1 in the DTS (or phy_number is set in the platform data). The SOC has 2 PHYs which can be used with the OTG port, and this code allows configuring the correct one. Note: This resolves the problem I was seeing where I couldn't get the USB driver working at all on a dragonboard, from cold boot. This patch depends on patch 5/14 from Ivan's msm USB patch set. It does not use DT for the register address, as there's no evidence that this address changes between SoC versions. Signed-off-by: Tim Bird <tim.bird@xxxxxxxxxxxxxx> --- drivers/usb/phy/phy-msm-usb.c | 14 ++++++++++++++ include/linux/usb/msm_hsusb_hw.h | 3 +++ 2 files changed, 17 insertions(+) diff --git a/drivers/usb/phy/phy-msm-usb.c b/drivers/usb/phy/phy-msm-usb.c index db8d963..9437bcf 100644 --- a/drivers/usb/phy/phy-msm-usb.c +++ b/drivers/usb/phy/phy-msm-usb.c @@ -1489,6 +1489,7 @@ static int msm_otg_probe(struct platform_device *pdev) struct resource *res; struct msm_otg *motg; struct usb_phy *phy; + void __iomem *phy_select; motg = devm_kzalloc(&pdev->dev, sizeof(struct msm_otg), GFP_KERNEL); if (!motg) { @@ -1553,6 +1554,19 @@ static int msm_otg_probe(struct platform_device *pdev) if (IS_ERR(motg->regs)) return PTR_ERR(motg->regs); + /* + * NOTE: The PHYs can be multiplexed between the chipidea controller + * and the dwc3 controller, using a single bit. It is important that + * the dwc3 driver does not set this bit in an incompatible way. + */ + if (motg->phy_number) { + phy_select = devm_ioremap_nocache(&pdev->dev, USB2_PHY_SEL, 4); + if (IS_ERR(phy_select)) + return PTR_ERR(phy_select); + /* Enable second PHY with the OTG port */ + writel_relaxed(0x1, phy_select); + } + dev_info(&pdev->dev, "OTG regs = %p\n", motg->regs); motg->irq = platform_get_irq(pdev, 0); diff --git a/include/linux/usb/msm_hsusb_hw.h b/include/linux/usb/msm_hsusb_hw.h index 98d3dd8..a29f603 100644 --- a/include/linux/usb/msm_hsusb_hw.h +++ b/include/linux/usb/msm_hsusb_hw.h @@ -16,6 +16,9 @@ #ifndef __LINUX_USB_GADGET_MSM72K_UDC_H__ #define __LINUX_USB_GADGET_MSM72K_UDC_H__ +/* USB phy selector - in TCSR address range */ +#define USB2_PHY_SEL 0xfd4ab000 + #define USB_AHBBURST (MSM_USB_BASE + 0x0090) #define USB_AHBMODE (MSM_USB_BASE + 0x0098) #define USB_CAPLENGTH (MSM_USB_BASE + 0x0100) /* 8 bit */ -- 1.8.3.2 -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html