On Tue, 2013-08-20 at 10:01 -0500, Kumar Gala wrote: > On Aug 20, 2013, at 9:54 AM, Ivan T. Ivanov wrote: > > > > > Hi, > > > > On Tue, 2013-08-20 at 09:33 -0500, Felipe Balbi wrote: > >> On Tue, Aug 20, 2013 at 05:09:11PM +0300, Ivan T. Ivanov wrote: > >>> Hi, > >>> > >>> On Tue, 2013-08-20 at 08:37 -0500, Felipe Balbi wrote: > >>>> Hi, > >>>> > >>>> On Tue, Aug 20, 2013 at 04:32:23PM +0300, Ivan T. Ivanov wrote: > >>>>>> On Tue, Aug 20, 2013 at 12:56:04PM +0300, Ivan T. Ivanov wrote: > >>>>>>> From: "Ivan T. Ivanov" <iivanov@xxxxxxxxxx> > >>>>>>> > >>>>>>> These drivers handles control and configuration of the HS > >>>>>>> and SS USB PHY transceivers. They are part of the driver > >>>>>>> which manage Synopsys DesignWare USB3 controller stack > >>>>>>> inside Qualcomm SoC's. > >>>>>>> > >>>>>>> Signed-off-by: Ivan T. Ivanov <iivanov@xxxxxxxxxx> > >>>>>>> --- > >>>>>>> drivers/usb/phy/Kconfig | 11 ++ > >>>>>>> drivers/usb/phy/Makefile | 2 + > >>>>>>> drivers/usb/phy/phy-msm-dwc3-hs.c | 327 ++++++++++++++++++++++++++++++++ > >>>>>>> drivers/usb/phy/phy-msm-dwc3-ss.c | 374 +++++++++++++++++++++++++++++++++++++ > >>>>>> > >>>>>> please rename these PHY drivers, they have nothing to do with DWC3. PHYs > >>>>>> don't care about the USB controller. > >>>>> > >>>>> I think they are SNPS DesignWare PHY's, additionally > >>>>> wrapped with Qualcomm logic. I could substitute "dwc3" > >>>>> with just "dw", which will be more correct. > >>>> > >>>> alright, thank you. Let's add Paul to the loop since he might have very > >>>> good insight in the synopsys PHYs. > >>>> > >>>> mental note: if any other platform shows up with Synopsys PHY, ask them > >>>> to use this driver instead :-) > >>> > >>> I really doubt that this will bi possible. Control of the PHY's is > >>> not directly trough ULPI, UTMI or PIPE3 interfaces, but trough > >>> QSCRATCH registers, which of course is highly Qualcomm specific. > >> > >> isn't it a memory mapped IP ? doesn't synopsys provide their own set of > >> registers ? > > > > From what I see it is not directly mapped. How QSCRATCH write and > > reads transactions are translated to DW IP is unclear to me. > > > I think the question is how does SW access them? "USB QSCRATCH Hardware registers" don't ask me what is this :-) or like Pawel says: "it depends on the SOC" . Ivan > > - k > -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
