From my experience this is caused by some (or all) drives not being in
dma.
run hdparm /dev/hd* (sd*) and make sure using_dma is on, you can also check what kind of dma is enabled with hdparm -i <device>
if it's not, give hdparm -d1 -c1 <dev> (d for dma and c for 32-bit) and hopefully it will turn on. you can run hdparm -tT <dev> before and after you do this to test the difference.
If dma doesn't turn on most likely you haven't compiled support for your board into your kernel, so if hdparm fails, give that a look
as for WHY it's dirty, either it has never synced in the first place, or it was unmounted unclean, happens to me most by power failure (or me kicking my power supply)
On Fri, 18 Feb 2005, urgrue wrote:
ive set up a software raid. md0 and md1 are RAID-0 (two identical SATA drives on each) and md2 is a RAID-1 consisting of md0 and md1. it works, but:
Personalities : [linear] [raid0] [raid1] [raid5] read_ahead 1024 sectors
md2 : active raid1 md1[1] md0[0]
490223168 blocks [2/2] [UU]
[========>............] resync = 43.6% (213810348/490223168) finish=18185.0min speed=252K/sec
md1 : active raid0 sdd1[1] [dev 08:21][0]
490223232 blocks 32k chunks
md0 : active raid0 sdb1[1] [dev 08:01][0]
490223232 blocks 32k chunks
and mdadm --detail /dev/md2 shows md2: State : dirty, resyncing Active Devices : 2 Working Devices : 2 Failed Devices : 0 Spare Devices : 0 Rebuild Status : 43% complete
question 1: why is it dirty? i just set this up a few days ago. should i be concerned, is something faulty? the individual RAID-0 drives md0 and md1 report nothing out of the ordinary.
question 2: why is it piddling along at 252K/sec? at this rate resync will take weeks.
-
: send the line "unsubscribe linux-admin" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
- : send the line "unsubscribe linux-admin" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
