Hi all.
I have something very strange going on with Traceroute.
I have 3 ethernet interfaces, all to internal networks, eth0 eth1 and eth2, and ppp0 which is the interface for my pci dsl modem card. However, traceroute will, unless I give it the -i switch, always usse eth0 to try and do a trace. The rest of the network seems to work fine i.e. other programs know where their packets should be going.
My routing table i below.
Any Thoughts?
Thanks in advance.
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
lo1.plusnet.pth * 255.255.255.255 UH 0 0 0 ppp0
192.168.3.0 * 255.255.255.0 U 0 0 0 eth2
192.168.2.0 * 255.255.255.0 U 0 0 0 eth1
192.168.1.0 * 255.255.255.0 U 0 0 0 eth0
loopback localhost 255.0.0.0 UG 0 0 0 lo
default lo1.plusnet.pth 0.0.0.0 UG 0 0 0 ppp0
-- Toby Fisher Email: toby@xxxxxxxxxxxxxx Tel.: +44(0)1480 417272 Mobile: +44(0)7974 363239 ICQ: #61744808 - : send the line "unsubscribe linux-admin" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
