The CRC PWM controller has a clock-divider which divides the clock with a value between 1-128. But as can seen from the PWM_DIV_CLK_xxx defines, this range maps to a register value of 0-127. So after calculating the clock-divider we must subtract 1 to get the register value, unless the requested frequency was so high that the calculation has already resulted in a (rounded) divider value of 0. Note that before this fix, setting a period of PWM_MAX_PERIOD_NS which corresponds to the max. divider value of 128 could have resulted in a bug where the code would use 128 as divider-register value which would have resulted in an actual divider value of 0 (and the enable bit being set). A rounding error stopped this bug from actually happen. This same rounding error means that after the subtraction of 1 it is impossible to set the divider to 128. Also bump PWM_MAX_PERIOD_NS by 1 ns to allow setting a divider of 128 (register-value 127). Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx> --- drivers/pwm/pwm-crc.c | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-) diff --git a/drivers/pwm/pwm-crc.c b/drivers/pwm/pwm-crc.c index 43fc912c1fe9..5ba2a65c524c 100644 --- a/drivers/pwm/pwm-crc.c +++ b/drivers/pwm/pwm-crc.c @@ -22,7 +22,7 @@ #define PWM_MAX_LEVEL 0xFF #define PWM_BASE_CLK_MHZ 6 /* 6 MHz */ -#define PWM_MAX_PERIOD_NS 5461333 /* 183 Hz */ +#define PWM_MAX_PERIOD_NS 5461334 /* 183 Hz */ #define NSEC_PER_MHZ 1000 @@ -75,6 +75,9 @@ static int crc_pwm_config(struct pwm_chip *c, struct pwm_device *pwm, /* changing the clk divisor, need to disable fisrt */ crc_pwm_disable(c, pwm); clk_div = PWM_BASE_CLK_MHZ * period_ns / (256 * NSEC_PER_MHZ); + /* clk_div 1 - 128, maps to register values 0-127 */ + if (clk_div > 0) + clk_div--; regmap_write(crc_pwm->regmap, PWM0_CLK_DIV, clk_div | PWM_OUTPUT_ENABLE); -- 2.26.2
