In some cases we might need to have an IRQ domain created out of software node.
One of such cases is DesignWare GPIO driver when it's instantiated from
half-baked ACPI table (alas, we can't fix it for devices which are few years
on market) and thus using software nodes to quirk this up. But the driver
is using IRQ domains based on per GPIO port firmware nodes, which are in
the above case software ones. This brings a warning message to be printed
[ 73.957183] irq: Invalid fwnode type for irqdomain
and creates an unknown IRQ domain.
When we allow software node to be correct one for IRQ domain we will
get rid of the warning message and nice domain name at the same time:
% ls -1 /sys/kernel/debug/irq/domains/
...
intel-quark-dw-apb-gpio:portA
Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
kernel/irq/irqdomain.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/kernel/irq/irqdomain.c b/kernel/irq/irqdomain.c
index c6204bc606a2..e4ebc5398ef5 100644
--- a/kernel/irq/irqdomain.c
+++ b/kernel/irq/irqdomain.c
@@ -161,7 +161,8 @@ struct irq_domain *__irq_domain_add(struct fwnode_handle *fwnode, int size,
domain->name = fwid->name;
break;
}
- } else if (is_of_node(fwnode) || is_acpi_device_node(fwnode)) {
+ } else if (is_of_node(fwnode) || is_acpi_device_node(fwnode) ||
+ is_software_node(fwnode)) {
char *name;
/*
--
2.26.2
