The Meegopad T08 hdmi-stick (think Intel computestick) has a brcm43430
wifi/bt combo chip. The BCM2E90 ACPI device describing the BT part does
contain a valid ActiveLow GpioInt entry, but the GPIO it points to never
goes low, so either the IRQ pin is not connected, or the ACPI resource-
table points to the wrong GPIO.
Eitherway things will not work if we try to use the specified IRQ, this
commits adds a DMI based broken-irq blacklist and disables use of the IRQ
and thus also runtime-pm for devices on this list.
This blacklist starts with the the Meegopad T08, fixing bluetooth not
working on this hdmi-stick. Since this is not a battery powered device
the loss of runtime-pm is not really an issue.
Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
---
drivers/bluetooth/hci_bcm.c | 23 +++++++++++++++++++++++
1 file changed, 23 insertions(+)
diff --git a/drivers/bluetooth/hci_bcm.c b/drivers/bluetooth/hci_bcm.c
index 52cbd18f6ed1..26e4a0cb27c1 100644
--- a/drivers/bluetooth/hci_bcm.c
+++ b/drivers/bluetooth/hci_bcm.c
@@ -794,6 +794,20 @@ static const struct acpi_gpio_mapping acpi_bcm_int_first_gpios[] = {
{ },
};
+/* Some firmware reports an IRQ which does not work (wrong pin in fw table?) */
+static const struct dmi_system_id bcm_broken_irq_dmi_table[] = {
+ {
+ .ident = "Meegopad T08",
+ .matches = {
+ DMI_EXACT_MATCH(DMI_BOARD_VENDOR,
+ "To be filled by OEM."),
+ DMI_EXACT_MATCH(DMI_BOARD_NAME, "T3 MRD"),
+ DMI_EXACT_MATCH(DMI_BOARD_VERSION, "V1.1"),
+ },
+ },
+ { }
+};
+
#ifdef CONFIG_ACPI
/* IRQ polarity of some chipsets are not defined correctly in ACPI table. */
static const struct dmi_system_id bcm_active_low_irq_dmi_table[] = {
@@ -911,6 +925,8 @@ static int bcm_gpio_set_shutdown(struct bcm_device *dev, bool powered)
static int bcm_get_resources(struct bcm_device *dev)
{
+ const struct dmi_system_id *dmi_id;
+
dev->name = dev_name(dev->dev);
if (x86_apple_machine && !bcm_apple_get_resources(dev))
@@ -943,6 +959,13 @@ static int bcm_get_resources(struct bcm_device *dev)
dev->irq = gpiod_to_irq(gpio);
}
+ dmi_id = dmi_first_match(bcm_broken_irq_dmi_table);
+ if (dmi_id) {
+ dev_info(dev->dev, "%s: Has a broken IRQ config, disabling IRQ support / runtime-pm\n",
+ dmi_id->ident);
+ dev->irq = 0;
+ }
+
dev_dbg(dev->dev, "BCM irq: %d\n", dev->irq);
return 0;
}
--
2.17.0.rc2
--
To unsubscribe from this list: send the line "unsubscribe linux-acpi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
