On Tue, Jan 30, 2018 at 8:07 AM, Kai-Heng Feng <kai.heng.feng@xxxxxxxxxxxxx> wrote: > The i2c touchpad on Dell XPS 9570 and Precision M5530 doesn't work out > of box. > > The touchpad relies on its _INI method to update its _HID value from > XXXX0000 to SYNA2393. > Also, the _STA relies on value of I2CN to report correct status. > > Set acpi_gbl_parse_table_as_term_list so the value of I2CN can be > correctly set up, and _INI can get run. The ACPI table in this machine > is designed to get parsed this way. > > Also, change the quirk table to a more generic name. > +static int set_gbl_term_list(const struct dmi_system_id *id) > +{ > + pr_notice("%s detected - parse the entire table as a term_list\n", > + id->ident); > + acpi_gbl_parse_table_as_term_list = 1; > + return 0; > +} > #endif The above should be outside of another #ifdef. Basically after the above #endif. > #else > #endif > @@ -1005,7 +1034,7 @@ void __init acpi_early_init(void) > * If the machine falls into the DMI check table, > * DSDT will be copied to memory > */ It might make sense to adjust comment above that it's about quirks in general. And, if needed, move current content to actual DMI group of records. > - dmi_check_system(dsdt_dmi_table); > + dmi_check_system(acpi_quirks_dmi_table); -- With Best Regards, Andy Shevchenko -- To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html