Hi,
On 17-03-17 18:33, Andy Shevchenko wrote:
On Fri, 2017-03-17 at 10:55 +0100, Hans de Goede wrote:
Add support for monitoring an extcon device with SDP/CDP/DCP and HOST
cables and adjust ilimit and enable/disable the 5v boost converter
accordingly. This is necessary on systems where the PSEL pin is
hardwired
high and ILIM needs to be set by software based on the detected
charger
type.
config CHARGER_BQ24190
tristate "TI BQ24190 battery charger driver"
depends on I2C
+ depends on EXTCON
I dunno what is preferred here, but if we would like to keep
compatibility with previous configurations "select" should be used over
"depends on".
select really should only be used for hidden options,
using select in other scenarios leads to all sort of
problems (hard to debug Kconfig dependency loops).
+static void bq24190_extcon_work(struct work_struct *work)
+{
+ struct bq24190_dev_info *bdi =
+ container_of(work, struct bq24190_dev_info,
extcon_work);
+ int ret, iinlim = 0;
+
+ if (extcon_get_state(bdi->extcon, EXTCON_CHG_USB_SDP) == 1)
+ iinlim = 500000;
+ else if (extcon_get_state(bdi->extcon, EXTCON_CHG_USB_CDP) ==
1 ||
+ extcon_get_state(bdi->extcon, EXTCON_CHG_USB_ACA) ==
1)
+ iinlim = 1500000;
+ else if (extcon_get_state(bdi->extcon, EXTCON_CHG_USB_DCP) ==
1)
+ iinlim = 2000000;
+
+ if (iinlim) {
Could be possible to call below unconditionally here (use 0)?
If there is no Vbus setting iinlim is not useful, the charger
will reset it to a default as soon as Vbus comes up and i2c
transactions are not free.
+ ret = bq24190_set_field_val(bdi, BQ24190_REG_ISC,
+ BQ24190_REG_ISC_IINLIM_MASK,
+ BQ24190_REG_ISC_IINLIM_SHIFT,
+ bq24190_iinlim_values,
+ ARRAY_SIZE(bq24190_iinlim_values),
+ iinlim);
+ if (ret)
+ dev_err(bdi->dev, "Can't set IINLIM: %d\n",
ret);
+ }
Perhaps make above as a helper?
In that case no need for "if (iinlim)" and perhaps switch-case might be
used instead of if-else-if (latter is up to you).
I prefer to keep this as is.
Thanks & Regards,
Hans
--
To unsubscribe from this list: send the line "unsubscribe linux-acpi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
