[PATCH v2 1/2] gpio / CrystalCove: support virtual GPIO

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



The virtual GPIO introduced in ACPI table of Baytrail-T based system is
used to solve a problem under Windows. We do not have such problems
under Linux so we do not actually need them. But we have to tell GPIO
library that the Crystal Cove GPIO chip has this many GPIO pins or the
common GPIO handler will refuse any access to those high number GPIO
pins, which will resulted in a failure evaluation of every ACPI control
method that is used to turn on/off power resource and/or report sensor
temperatures.

Signed-off-by: Aaron Lu <aaron.lu@xxxxxxxxx>
---
v2: remove the hunk to increase NR_GPIO to 512.

 drivers/gpio/gpio-crystalcove.c | 19 ++++++++++++++++---
 1 file changed, 16 insertions(+), 3 deletions(-)

diff --git a/drivers/gpio/gpio-crystalcove.c b/drivers/gpio/gpio-crystalcove.c
index e3712f0e51ab..186b76ef71a1 100644
--- a/drivers/gpio/gpio-crystalcove.c
+++ b/drivers/gpio/gpio-crystalcove.c
@@ -24,6 +24,7 @@
 #include <linux/mfd/intel_soc_pmic.h>
 
 #define CRYSTALCOVE_GPIO_NUM	16
+#define CRYSTALCOVE_VGPIO_NUM	0x5e
 
 #define UPDATE_IRQ_TYPE		BIT(0)
 #define UPDATE_IRQ_MASK		BIT(1)
@@ -130,6 +131,9 @@ static int crystalcove_gpio_dir_in(struct gpio_chip *chip, unsigned gpio)
 {
 	struct crystalcove_gpio *cg = to_cg(chip);
 
+	if (gpio > CRYSTALCOVE_VGPIO_NUM)
+		return 0;
+
 	return regmap_write(cg->regmap, to_reg(gpio, CTRL_OUT),
 			    CTLO_INPUT_SET);
 }
@@ -139,6 +143,9 @@ static int crystalcove_gpio_dir_out(struct gpio_chip *chip, unsigned gpio,
 {
 	struct crystalcove_gpio *cg = to_cg(chip);
 
+	if (gpio > CRYSTALCOVE_VGPIO_NUM)
+		return 0;
+
 	return regmap_write(cg->regmap, to_reg(gpio, CTRL_OUT),
 			    CTLO_OUTPUT_SET | value);
 }
@@ -149,6 +156,9 @@ static int crystalcove_gpio_get(struct gpio_chip *chip, unsigned gpio)
 	int ret;
 	unsigned int val;
 
+	if (gpio > CRYSTALCOVE_VGPIO_NUM)
+		return 0;
+
 	ret = regmap_read(cg->regmap, to_reg(gpio, CTRL_IN), &val);
 	if (ret)
 		return ret;
@@ -161,6 +171,9 @@ static void crystalcove_gpio_set(struct gpio_chip *chip,
 {
 	struct crystalcove_gpio *cg = to_cg(chip);
 
+	if (gpio > CRYSTALCOVE_VGPIO_NUM)
+		return;
+
 	if (value)
 		regmap_update_bits(cg->regmap, to_reg(gpio, CTRL_OUT), 1, 1);
 	else
@@ -256,7 +269,7 @@ static irqreturn_t crystalcove_gpio_irq_handler(int irq, void *data)
 
 	pending = p0 | p1 << 8;
 
-	for (gpio = 0; gpio < cg->chip.ngpio; gpio++) {
+	for (gpio = 0; gpio < CRYSTALCOVE_GPIO_NUM; gpio++) {
 		if (pending & BIT(gpio)) {
 			virq = irq_find_mapping(cg->chip.irqdomain, gpio);
 			generic_handle_irq(virq);
@@ -273,7 +286,7 @@ static void crystalcove_gpio_dbg_show(struct seq_file *s,
 	int gpio, offset;
 	unsigned int ctlo, ctli, mirqs0, mirqsx, irq;
 
-	for (gpio = 0; gpio < cg->chip.ngpio; gpio++) {
+	for (gpio = 0; gpio < CRYSTALCOVE_GPIO_NUM; gpio++) {
 		regmap_read(cg->regmap, to_reg(gpio, CTRL_OUT), &ctlo);
 		regmap_read(cg->regmap, to_reg(gpio, CTRL_IN), &ctli);
 		regmap_read(cg->regmap, gpio < 8 ? MGPIO0IRQS0 : MGPIO1IRQS0,
@@ -320,7 +333,7 @@ static int crystalcove_gpio_probe(struct platform_device *pdev)
 	cg->chip.get = crystalcove_gpio_get;
 	cg->chip.set = crystalcove_gpio_set;
 	cg->chip.base = -1;
-	cg->chip.ngpio = CRYSTALCOVE_GPIO_NUM;
+	cg->chip.ngpio = CRYSTALCOVE_VGPIO_NUM;
 	cg->chip.can_sleep = true;
 	cg->chip.dev = dev;
 	cg->chip.dbg_show = crystalcove_gpio_dbg_show;
-- 
1.9.3

--
To unsubscribe from this list: send the line "unsubscribe linux-acpi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux IBM ACPI]     [Linux Power Management]     [Linux Kernel]     [Linux Laptop]     [Kernel Newbies]     [Share Photos]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux