On Monday 11 June 2007 13:10:23 you wrote: > I got the same effect: I can't see the temperature change dynamically, > degree by degree. Also, in a test, the sensor went up to 60-65C and the > trip-point did't activate. This was with polling set to 1. Clarification: Using a polling frequency of 1 second (*) I didn't see the ACPI temperature increase at all. "sensors" has shown the temperature increasing, but reaching 60-65C the trip-point didn't activate. * The frequency is measured in "times/second" or Hz. Shouldn't "polling_frequency" be renamed to "polling_interval" if it is measured in seconds? Regards, Mircea - To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
