Timothy This software Agere packages agrsm06pci-2.1.80~20100106.tar.gz or agrsm-11c11040-2.1.80~20091225.tar.bz2 at http://linmodems.technion.ac.il/packages/ltmodem/11c11040/ should in principle support your USB modem, But there is yet to be a success report despite several tries. Loading agrmodem, agrserial will create a port /dev/ttyAGS3, which is the true modem port. MarvS On Tue, Jul 27, 2010 at 10:40 PM, Timothy Pang <timothy.pang@xxxxxxxxxxxx> wrote: > Dear Marvin, > > > > I am appreciate that if you would tell me how to setup the USB modem in SUSE > enterprise 10? As I know e.g for the COM will use ttyS0 but usb should > ttyUSB0 or others. But in /var/log/messages only show as below. Didn't show > ttyUSB0 or others. Please advise where can I found it and set it ! If no, > How can I set in inittab ? > > > > # modem getty > > mo:235:respawn:/usr/sbin/mgetty –s 38400 /dev/modem > > Jul 26 08:08:55 demo1 kernel: usb 1-4: new high speed USB device using > ehci_hcd and address 8 > Jul 26 08:08:55 demo1 kernel: usb 1-4: new device found, idVendor=047e, > idProduct=2892 > Jul 26 08:08:55 demo1 kernel: usb 1-4: new device strings: Mfr=1, Product=2, > SerialNumber=0 > Jul 26 08:08:55 demo1 kernel: usb 1-4: Product: Agere USB2.0 V.92 SoftModem > Jul 26 08:08:55 demo1 kernel: usb 1-4: Manufacturer: Agere Systems > Jul 26 08:08:55 demo1 kernel: usb 1-4: configuration #2 chosen from 1 choice > > > > > > 03: USB 00.0: 0000 Unclassified device > > [Created at usb.123] > > UDI: /org/freedesktop/Hal/devices/usb_device_47e_2892_noserial_if0 > > Unique ID: 1Yic.Yt+jriS6j2B > > Parent ID: k4bc.eTsZyIgHxO4 > > SysFS ID: /devices/pci0000:00/0000:00:1d.7/usb1/1-1/1-1:2.0 > > SysFS BusID: 1-1:2.0 > > Hardware Class: unknown > > Model: "Agere (Lucent) Agere USB2.0 V.92 SoftModem" > > Hotplug: USB > > Vendor: usb 0x047e "Agere (Lucent)" > > Device: usb 0x2892 "Agere USB2.0 V.92 SoftModem" > > Revision: "2.00" > > Speed: 480 Mbps > > Module Alias: "usb:v047Ep2892d0200dcFFdsc00dp00icFFisc00ip00" > > Config Status: cfg=no, avail=yes, need=no, active=unknown > > Attached to: #2 (Hub) > > > > Your help will be very very appreciated! > > > > Many Thanks/Timothy
