Hi people. I tried very hard to install this winmodem on my linux laptop. I have reached to a certain point where I managed to get the driver installed and working but wvdialconf is not detecting my modem. It just goes through the baud rates and then exits. Below is some information of my hardware and modem setup. Maybe someone can give me some information. TrendNet External USB modem. Firmware version: B1.1 Model: TFM-560U Using Gentoo Linux kernel 2.6.30-gentoo-r8 ScanModem detects Predictive diagnostics for card in bus 002: Modem chipset detected on SLOT="Bus 002 Device 013:" NAME="Agere Systems, Inc. (Lucent) Systems Soft Modem" bus=002 USBmodemID=047e:2892 IDENT=agrsm Driver=agrsm For a detailed USB cellphone usage report, see http://linmodems.technion.ac.il/bigarch/archive-eighth/msg03240.html For candidate modem in: 002 Agere Systems, Inc. (Lucent) Systems Soft Modem Primary device ID: 047e:2892 Support type needed or chipset: agrsm I try agrsm-20090502.tar.gz = fail I try agrsm048pci-2.1.60.tar.gz = fail I try agrsm06pci-2.1.80-20100106. tar.gz = success I run "agr_softmodem" after I compile and install driver "agrsm06pci-2.1.80-20100106" Output of "ps" command showing AgereMdmDaemon running in background localhost agrsm06pci-2.1.80-20100106 # ps PID TTY TIME CMD 5086 pts/1 00:00:00 su 5092 pts/1 00:00:00 bash 5504 pts/1 00:00:00 AgereMdmDaemon 6428 pts/1 00:00:00 ps Output of "lsmod" command showing loaded modules localhostagrsm06pci-2.1.80-20100106 # lsmod Module Size Used by agrserial 10096 0 agrmodem 1331844 1 fglrx 1947356 28 intel_agp 22932 0 agpgart 26564 2 fglrx,intel_agp output of "/var/log/kern.log" showing logs when I run wvdialconf /etc/dial.conf Mar 9 14:51:48 toshi kernel: * Hello Agere Driver PCIe ** Mar 9 14:51:48 toshi kernel: Loading module Agere Modem Controller driver version 2.1.80-Red Flag NE 5.0 (2007-10-1) Mar 9 14:51:48 toshi kernel: ttyAGS3 at I/O 0x400 (irq = 3) is a AgereModem Mar 9 14:51:48 toshi kernel: Loading module Agere Modem Interface driver version 2.1.80.0Red Flag 5.0 NE (2007-10-01) Mar 9 14:51:48 toshi kernel: ==> codecType = 0x31 Mar 9 14:51:48 toshi kernel: App PID = 5837 Mar 9 14:52:05 toshi kernel: ==> codecType = 0x31 Mar 9 14:56:39 toshi kernel: ==> codecType = 0x31 Mar 9 14:57:50 toshi kernel: ==> codecType = 0x31 Mar 9 15:00:26 toshi kernel: ==> codecType = 0x31 When I run minicom, it connects to the modem but when I type commands like ATZ and ATH I get no response. So what you guys think? Is there a way to detect this modem or I need some extra config somewhere. Thanks. Georg
