Jayarajan, scanModem reports that you need hsfmodem drivers: Support type needed or chipset: hsfmodem Writing DOCs/Intel.txt For owners of a Dell PCs with Conexant HSF modems, a driver source package with full speed enabled is available, but requires driver compiling. Read DOCs/Conexant.txt Start at http://www.linuxant.com/drivers/hsf/downloads-license.php to find the hsfmodem package matching your System. For several Linux distros, there are precompiled drivers matched to specific kernels. These have within the FileName, your KernelVersion: 2.6.28_13_generic They can be found through http://www.linuxant.com/drivers/hsf/full/downloads.php A more precise location may be given a few paragraphs below. If an EXACT Match with your your KernelVersion is not found, one of the "Generic packages with source" near the bottom of the page must be used. Downloaded packages must be moved into the Linux partition (home folder is OK) and unzipped with: unzip hsf*.zip The installation command for a .deb suffic packages is, with root/adm permission: sudo dpkg -i hsf*.deb while for .rpm suffix it is, with: rpm -i hsf*.rpm From http://www.linuxant.com/drivers/hsf/full/downloads-ubuntu-x86.php download hsfmodem-7.80.02.02full_k2.6.28_13_generic_ubuntu_i386.deb.zip Under Linux unpack with: $ unzip hsfmodem*.zip Then install with: $ sudo dpkg -i hsfmodem*.deb Subsequently, the modem should be found with $ sudo wvdialconf /etc/wvdial.conf Edit in your personal information with: $ sudo gedit /etc/wvdial.conf and try dialing out with: $ sudo wvdial. See DOCs/Testing.txt for details. Read DOCs/Conexant.txt But if the modem is nonresponsive after you install the drivers, then please follow the directions scanModem gave here: Modem interrupt assignment and sharing: 5: 3015840 XT-PIC-XT ipw2200, Intel 82801DB-ICH4 --- Bootup diagnostics for card in PCI slot 00:1f.6 ---- [ 0.579752] pci 0000:00:1f.6: reg 10 io port: [0xd400-0xd4ff] [ 0.579758] pci 0000:00:1f.6: reg 14 io port: [0xd080-0xd0ff] [ 0.580027] pci 0000:00:1f.6: PME# supported from D0 D3hot D3cold [ 0.580031] pci 0000:00:1f.6: PME# disabled [ 2.109390] serial 0000:00:1f.6: PCI INT B -> Link[LNKB] -> GSI 5 (level, low) -> IRQ 5 [ 2.109398] serial 0000:00:1f.6: PCI INT B disabled The PCI slot 00:1f.6 of the modem card may be disabled early in a bootup process, but then enabled later. If modem drivers load but the modem is not responsive, read DOCs/Bootup.txt about possible fixes. Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx if help is needed. Regards, Antonio On 6/26/09, Jayarajan P M <jayarajan@xxxxxxxxxxxxxxx> wrote: > Hi, > > I am unable to install my PCMCIA Modem in Linux. > > Laptop Make & Model: > DELL Latitude D400 > Intel Centrino 1.60 Ghz > Memory: 512 MB > > Distribution: Ubuntu 9.04 (jaunty) > Kernel: Linux 2.6.28-11-generic > Environment: GNOME 2.26.1 Build Date Wednesday 06 May 2009 > > Manufacturer: ZTE Corporation > 800MHz CDMA 1X > Model: MC315+ > PCMCIA TYPE-II > Wireless Modem > > ***************ModemData.txt*************** > > -------------------------- System information > ---------------------------- > CPU=i686, > Linux version 2.6.28-13-generic (buildd@palmer) (gcc version 4.3.3 > (Ubuntu 4.3.3-5ubuntu4) ) #44-Ubuntu SMP Tue Jun 2 07:57:31 UTC 2009 > scanModem update of: 2009_05_31 > The modem symbolic link is /dev/modem -> /dev/ttyS0 > There are no blacklisted modem drivers in /etc/modprobe* files > Potentially useful modem drivers now loaded are: > > > Attached USB devices are: > ID 413c:8000 Dell Computer Corp. BC02 Bluetooth USB Adapter > If a cellphone is not detected, see > http://ubuntuforums.org/archive/index.php/t-878554.html > > If a USB modem or cellphone is attached and was not detected, please > provide available information in your request to discuss@xxxxxxxxxxxxx > > For candidate card in slot 00:1f.6, firmware information and bootup > diagnostics are: > PCI slot PCI ID SubsystemID Name > ---------- --------- --------- -------------- > 00:1f.6 8086:24c6 14f1:5422 Modem: Intel Corporation 82801DB/DBL/DBM > > Modem interrupt assignment and sharing: > 5: 3015840 XT-PIC-XT ipw2200, Intel 82801DB-ICH4 > --- Bootup diagnostics for card in PCI slot 00:1f.6 ---- > [ 0.579752] pci 0000:00:1f.6: reg 10 io port: [0xd400-0xd4ff] > [ 0.579758] pci 0000:00:1f.6: reg 14 io port: [0xd080-0xd0ff] > [ 0.580027] pci 0000:00:1f.6: PME# supported from D0 D3hot D3cold > [ 0.580031] pci 0000:00:1f.6: PME# disabled > [ 2.109390] serial 0000:00:1f.6: PCI INT B -> Link[LNKB] -> GSI 5 > (level, low) -> IRQ 5 > [ 2.109398] serial 0000:00:1f.6: PCI INT B disabled > > The PCI slot 00:1f.6 of the modem card may be disabled early in > a bootup process, but then enabled later. If modem drivers load > but the modem is not responsive, read DOCs/Bootup.txt about possible > fixes. > Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx > if help is needed. > > > > ===== Advanced Linux Sound Architecture (ALSA) diagnostics ===== > The ALSA packages provide audio support and also drivers for some > modems. > ALSA diagnostics are written during bootup to /proc/asound/ folders. > > The ALSA verion is 1.0.18 > The modem cards detected by "aplay -l" are: None > > > The /proc/asound/pcm file reports: > ----------------------- > 00-00: Intel ICH : Intel 82801DB-ICH4 : playback 1 : capture 1 > 00-01: Intel ICH - MIC ADC : Intel 82801DB-ICH4 - MIC ADC : capture 1 > 00-02: Intel ICH - MIC2 ADC : Intel 82801DB-ICH4 - MIC2 ADC : capture 1 > 00-03: Intel ICH - ADC2 : Intel 82801DB-ICH4 - ADC2 : capture 1 > 00-04: Intel ICH - IEC958 : Intel 82801DB-ICH4 - IEC958 : playback 1 > > about /proc/asound/cards: > ------------------------ > 0 [I82801DBICH4 ]: ICH4 - Intel 82801DB-ICH4 > Intel 82801DB-ICH4 with STAC9750,51 at irq 5 > === Finished firmware and bootup diagnostics, next deducing cogent > software. === > > Predictive diagnostics for card in bus 00:1f.6: > Modem chipset detected on > NAME="Modem: Intel Corporation 82801DB/DBL/DBM " > CLASS=0703 > PCIDEV=8086:24c6 > SUBSYS=14f1:5422 > IRQ=5 > SOFT=8086:24c6.MC97 > CodecArchived=CXT > CodecClass=CXT > IDENT=hsfmodem > Driver=hsfmodem-drivers > > For candidate modem in: 00:1f.6 > 0703 Modem: Intel Corporation 82801DB/DBL/DBM > Primary device ID: 8086:24c6 > Subsystem PCI_id 14f1:5422 > Softmodem codec or chipset from diagnostics: > from Archives: CXT, a Conexant type > using hsfmodem software. > CXTnn is a generic for all CXTnumbers, with Linuxant hsfmodem > software support. > > > Support type needed or chipset: hsfmodem > > > Writing DOCs/Intel.txt > > For owners of a Dell PCs with Conexant HSF modems, a driver source > package with full speed enabled is available, but requires driver > compiling. Read DOCs/Conexant.txt > > > Start at http://www.linuxant.com/drivers/hsf/downloads-license.php to > find the > hsfmodem package matching your System. For several Linux distros, there > are > precompiled drivers matched to specific kernels. These have within the > FileName, > your KernelVersion: 2.6.28_13_generic > They can be found through > http://www.linuxant.com/drivers/hsf/full/downloads.php > A more precise location may be given a few paragraphs below. > If an EXACT Match with your your KernelVersion is not found, one of the > "Generic packages with source" near the bottom of the page must be used. > Downloaded packages must be moved into the Linux partition (home folder > is OK) > and unzipped with: > unzip hsf*.zip > The installation command for a .deb suffic packages is, with root/adm > permission: > sudo dpkg -i hsf*.deb > while for .rpm suffix it is, with: > rpm -i hsf*.rpm > From http://www.linuxant.com/drivers/hsf/full/downloads-ubuntu-x86.php > download > hsfmodem-7.80.02.02full_k2.6.28_13_generic_ubuntu_i386.deb.zip > Under Linux unpack with: > $ unzip hsfmodem*.zip > Then install with: > $ sudo dpkg -i hsfmodem*.deb > Subsequently, the modem should be found with > $ sudo wvdialconf /etc/wvdial.conf > Edit in your personal information with: > $ sudo gedit /etc/wvdial.conf > and try dialing out with: > $ sudo wvdial. > See DOCs/Testing.txt for details. > > Read DOCs/Conexant.txt > > Writing DOCs/Conexant.txt > > > Completed candidate modem analyses. > > The base of the UDEV device file system is: /dev/.udev > > Versions adequately match for the compiler installed: 4.3.3 > and the compiler used in kernel assembly: 4.3.3 > > > > Minimal compiling resources appear complete: > make utility - /usr/bin/make > Compiler version 4.3 > linuc_headers base folder /lib/modules/2.6.28-13-generic/build > > However some compilations and executable functions may need additional > files, > in the FileNames.h (so called kernel "h"eaders) collection installed > in /usr/include/ . > For martian_modem, additional required packages are needed. The also > required headers of package libc6 are commonly installed by default. > Compiling hsfmodem drivers does require linux-libc-dev and libc6-dev > packages, for kernels 2.6.24 and later versions. > In not included on your install CD, search for them at > http://packages.ubuntu.com > or comparable Repository for other Linux distros. > When compiling ALSA drivers, the utility "patch" will also be needed. > > > > > If a driver compilation fails, with message including some lack of some > FileName.h (stdio.h for example), then > Some additional kernel-header files need installation to /usr/include. > The minimal additional packages are libc6-dev > and any of its dependents, under Ubuntu linux-libc-dev > > If an alternate ethernet connection is available, > $ apt-get update > $ apt-get -s install linux-kernel-devel > will install needed packages. > For Debian/Ubuntu related distributions, run the following command to > display the needed package list: > > Otherwise packages have to be found through http://packages.ubuntu.com > Once downloaded and transferred into a Linux partition, > they can be installed alltogether with: > $ sudo dpkg -i *.deb > > Checking settings of: /etc/ppp/options > asyncmap 0 > noauth > crtscts > lock > hide-password > modem > proxyarp > lcp-echo-interval 30 > lcp-echo-failure 4 > noipx > > In case of a message like: > Warning: Could not modify /etc/ppp/pap-secrets: Permission denied > see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html > > Read Modem/DOCs/YourSystem.txt concerning other COMM channels: eth0 eth1 > Which can interfere with Browser naviagation. > > Don't worry about the following, it is for experts should trouble > shooting be necessary. > ========================================================== > > Checking for modem support lines: > -------------------------------------- > /device/modem symbolic link: lrwxrwxrwx 1 root root 10 2009-06-25 > 17:05 /dev/modem -> /dev/ttyS0 > slmodemd created symbolic link /dev/ttySL0: > Within /etc/udev/ files: > > Within /etc/modprobe.conf files: > /etc/modprobe.d/alsa-base.conf:options snd-atiixp-modem index=-2 > /etc/modprobe.d/alsa-base.conf:options snd-via82xx-modem index=-2 > /etc/modprobe.d/blacklist-modem.conf:# Uncomment these entries in order > to blacklist unwanted modem drivers > /etc/modprobe.d/blacklist-modem.conf:# blacklist snd-atiixp-modem > /etc/modprobe.d/blacklist-modem.conf:# blacklist snd-via82xx-modem > Within any ancient /etc/devfs files: > > Within ancient kernel 2.4.n /etc/module.conf files: > > --------- end modem support lines -------- > > >
