Mahdy Re: I downloaded http://www.linuxant.com/drivers/hsf/full/archive/hsfmodem-7.80.02.03full/hsfmodem_7.80.02.03full_k2.6.27_7_generic_ubuntu_i386.deb.zip for my modem then I deed your orders.it`s the result: ------- You must have read am email attended to someone else!! Per below, you need the martian software. MarvS On Tue, Feb 17, 2009 at 3:47 PM, Marvin Stodolsky <marvin.stodolsky@xxxxxxxxx> wrote: > Mahdy > > At At http://linmodems.technion.ac.il/packages/ltmodem/kernel-2.6/martian/ > you need the most recent martian-full package > Before compiling you must additionally install packages linux-libc-dev > and libc6-dev package. They may be on your install CD, or if not can > be downloaded through > http://packages.ubuntu.com. After downloaded and copied to your > Ubuntu partition, > install then with: > $ sudo dpkg -i li*.deb > Then you will be readly to use the martian-full package, which can be > unpacked with > $ tar zxf martian*.tar.gz > > However, there is a preliminary problem in > ===== > Modem interrupt assignment and sharing: > 11: 0 IO-APIC-fasteoi ehci_hcd:usb1, uhci_hcd:usb3 > --- Bootup diagnostics for card in PCI slot 00:0b.0 ---- > [ 0.752594] PCI: 0000:00:0b.0 reg 10 32bit mmio: [dfffff00, dfffffff] > [ 0.752605] PCI: 0000:00:0b.0 reg 14 io port: [ec00, ec07] > [ 0.752615] PCI: 0000:00:0b.0 reg 18 io port: [e800, e8ff] > [ 0.752658] pci 0000:00:0b.0: supports D2 > [ 0.752662] pci 0000:00:0b.0: PME# supported from D2 D3hot D3cold > [ 0.752670] pci 0000:00:0b.0: PME# disabled > > The PCI slot 00:0b.0 of the modem card may be disabled early in > a bootup process, but then enabled later. If modem drivers load > but the modem is not responsive, read DOCs/Bootup.txt about possible fixes. > Send dmesg.txt along with ModemData.txt to discuss@xxxxxxxxxxxxx > if help is needed. > ====== > The pci 0000:00:0b.0 must be enabled before > > Communication controller: Agere Systems LT WinModem " > CLASS=0780 > PCIDEV=11c1:044c > SUBSYS=11c1:044c > IRQ=11 > IDENT=Agere.DSP > ===== > can function under Ubuntu 2.6.27-7-generic. > > Whoever after installing the drivers, try a reboot and rerun scanModem. > Sometimes installing the driver helps. > > Report back presently. > > MarvS > scanModem maintainer > > On Tue, Feb 17, 2009 at 12:19 PM, mahdy mrn <mrmrn121@xxxxxxxxx> wrote: >> >> >
