Jayant
compiling is necessary packages must be installed, providing:
gcc-4.3 make kernel-source-2.6.25.5-1.1-pae
Then from near the bottom of
http://www.linuxant.com/drivers/hsf/full/downloads.php get the
hsfmodem-7.68.00.14full-1.i386.rpm.zip
Unzip ONLY under Linux:
$ unzip hsf*.zip
Use Konqueror to browse over/OpenFile
hsfmodem-7.68.00.14full-1.i386.rpm , to start the install.
A reboot may be necessary before the modem is properly detected.
$ su root
# wvdialconf /etc/wvdial.conf
should detect the modem.
Most expert support for the Conexant modems is from , "Support
(Jonathan)" <support@xxxxxxxxxxxx>,
Please send further queries to to discuss@xxxxxxxxxxxxx, not directly to me.
MarvS
Start at http://www.linuxant.com/drivers/hsf/full for
eventually download of a hsfmodem-7.68.00.07full_k.???.zip package
with ??? the package type (deb, rpm, tar etc)
These packages have compiled drivers but will also compile a driver,
if there is a mismatch between the resident kernel and provided driver.
The generic hsfmodem-7.68.00.07full.tar.gz package only provides
compiling support
Read DOCs/Conexant.txt
Writing DOCs/Conexant.txt
Completed candidate modem analyses.
The base of the UDEV device file system is: /dev/.udev
The kernel was compiled with gcc version 4.3.1 and a compiler is not installed
linux-headers-2.6.25.5-1.1-pae resources needed for compiling are not
manifestly ready!
If compiling is necessary packages must be installed, providing:
gcc-4.3 make kernel-source-2.6.25.5-1.1-pae
On Fri, Nov 21, 2008 at 1:00 PM, Jayant Ogale <jaogale@xxxxxxxxx> wrote:
> hi marvin,
> enclosed herewith modemdata.txt
> please let me know in details, how to configure modem.
> also let me know the correct procedure for dialling a dial-up network.
> thanks,
> jayant
>
> Only plain text email is forwarded by the Discuss@xxxxxxxxxxxxx List Server,
> as HTML can contain viruses. Use as the email Subject Line:
> YourName, YourCountry
> Welcome to openSUSE 11.0 (i586) - Kernel kernel 2.6.25.5-1.1-pae
> With this Subject Line cogent experts will be alerted, and useful
> case names left in the Archive.
> YourCountry will enable Country specific guidance. Linux experts in
> YourCountry
> can be found through: http://www.linux.org/groups/index.html.
> They will know your Country's modem code, which may be essential for
> dialup service.
> Responses from Discuss@xxxxxxxxxxxxx are sometimes blocked by an
> Internet Provider mail filters.
> So in a day, also check the Archived responses at http://www.linmodems.org
> -------------------------- System information ----------------------------
> CPU=i686,
> Welcome to openSUSE 11.0 (i586) - Kernel
> Linux version 2.6.25.5-1.1-pae (geeko@buildhost) (gcc version 4.3.1
> 20080507 (prerelease) [gcc-4_3-branch revision 135036] (SUSE Linux) )
> #1 SMP 2008-06-07 01:55:22 +0200
> scanModem update of: 2008_06_21
>
> There are no blacklisted modem drivers in /etc/modprobe* files
> Attached USB devices are:
> ID 1d6b:0001 Linux Foundation 1.1 root hub
> ID 1733:0101 Cellink Technology Co., Ltd RF Wireless Optical Mouse OP-701
> ID 03eb:0902 Atmel Corp.
> ID 1d6b:0001 Linux Foundation 1.1 root hub
> ID 1d6b:0001 Linux Foundation 1.1 root hub
> ID 1d6b:0001 Linux Foundation 1.1 root hub
> ID 1970:0000 Dane-Elec Corp. USA
> ID 1d6b:0002 Linux Foundation 2.0 root hub
>
> USB modems not recognized
>
> For candidate card in slot 00:1b.0, firmware information and bootup
> diagnostics are:
> PCI slot PCI ID SubsystemID Name
> ---------- --------- --------- --------------
> 00:1b.0 8086:2668 104d:81cc Audio device: Intel Corporation
> 82801FB/FBM/FR/FW/FRW
>
> Modem interrupt assignment and sharing:
> 19: 1265 IO-APIC-fasteoi uhci_hcd:usb3, HDA Intel
> --- Bootup diagnostics for card in PCI slot 00:1b.0 ----
> ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 19 (level, low) -> IRQ 19
> PCI: Setting latency timer of device 0000:00:1b.0 to 64
>
>
> ===== Advanced Linux Sound Architecture (ALSA) diagnostics =====
> The ALSA packages provide audio support and also drivers for some modems.
> ALSA diagnostics are written during bootup to /proc/asound/ folders.
>
> PCI slot 00:1b.0 has a High Definition Audio Card
> The drivers are in the kernel modules tree at:
> /lib/modules/2.6.25.5-1.1-pae/kernel/sound/pci/hda/snd-hda-intel.ko
>
> The ALSA verion is 1.0.16
> The modem cards detected by "aplay -l" are: None
>
>
> The /proc/asound/pcm file reports:
> -----------------------
> 00-00: ALC260 Analog : ALC260 Analog : playback 1 : capture 1
>
> about /proc/asound/cards:
> ------------------------
> 0 [Intel ]: HDA-Intel - HDA Intel
> HDA Intel at 0x80000000 irq 19
> === Finished firmware and bootup diagnostics, next deducing cogent software. ===
>
> Predictive diagnostics for card in bus 00:1b.0:
> Modem chipset detected on
> NAME="Audio device: Intel Corporation 82801FB/FBM/FR/FW/FRW "
> CLASS=0403
> PCIDEV=8086:2668
> SUBSYS=104d:81cc
> IRQ=19
> HDA=8086:2668
> SOFT=8086:2668.HDA
> ArchivedChip=0x14f12bfa
> CodecClass=14f1
> IDENT=hsfmodem
>
> For candidate modem in: 00:1b.0
> 0403 Audio device: Intel Corporation 82801FB/FBM/FR/FW/FRW
> Primary device ID: 8086:2668
> Subsystem PCI_id 104d:81cc
> Softmodem codec or chipset from diagnostics:
> from Archives:
>
>
>
> Support type needed or chipset: hsfmodem
>
>
> Writing DOCs/Intel.txt
>
> For owners of a Dell PCs with Conexant HSF modems, a driver source
> package with full speed enabled is available, but requires driver
> compiling. Read DOCs/Conexant.txt
>
> Start at http://www.linuxant.com/drivers/hsf/full for
> eventually download of a hsfmodem-7.68.00.07full_k.???.zip package
> with ??? the package type (deb, rpm, tar etc)
> These packages have compiled drivers but will also compile a driver,
> if there is a mismatch between the resident kernel and provided driver.
> The generic hsfmodem-7.68.00.07full.tar.gz package only provides
> compiling support
>
> Read DOCs/Conexant.txt
>
> Writing DOCs/Conexant.txt
>
>
> Completed candidate modem analyses.
>
> The base of the UDEV device file system is: /dev/.udev
>
> The kernel was compiled with gcc version 4.3.1 and a compiler is not installed
>
> linux-headers-2.6.25.5-1.1-pae resources needed for compiling are not
> manifestly ready!
>
> If compiling is necessary packages must be installed, providing:
> gcc-4.3 make kernel-source-2.6.25.5-1.1-pae
>
>
> If a driver compilation fails, with message including some lack of
> some FileName.h (stdio.h for example), then
> Some additional kernel-header files need installation to /usr/include.
> The minimal additional packages are libc6-dev
> and any of its dependents, under Ubuntu linux-libc-dev
>
> If an alternate ethernet connection is available,
> $ apt-get update
> $ apt-get -s install linux-kernel-devel
> will install needed packages.
> For Debian/Ubuntu related distributions, run the following command to
> display the needed package list:
>
> Otherwise packages have to be found through http://packages.ubuntu.com
> Once downloaded and transferred into a Linux partition,
> they can be installed alltogether with:
> $ sudo dpkg -i *.deb
>
>
> Checking pppd properties:
> -rwxr-xr-x 1 root dialout 304644 Jun 7 02:51 /usr/sbin/pppd
>
> In case of an "error 17" "serial loopback" problem, see:
> http://linmodems.technion.ac.il/linmodems/archive-sixth/msg02637.html
>
> To enable dialout without Root permission do:
> $ su - root (not for Ubuntu)
> chmod a+x /usr/sbin/pppd
> or under Ubuntu related Linuxes
> chmod a+x /usr/sbin/pppd
>
> Checking settings of: /etc/ppp/options
> noipdefault
> noauth
> crtscts
> lock
> modem
> asyncmap 0
> nodetach
> lcp-echo-interval 30
> lcp-echo-failure 4
> lcp-max-configure 60
> lcp-restart 2
> idle 600
> noipx
> file /etc/ppp/filters
>
> In case of a message like:
> Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
> see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html
>
> Read Modem/DOCs/YourSystem.txt concerning other COMM channels: eth0
> Which can interfere with Browser naviagation.
>
> Don't worry about the following, it is for experts should trouble
> shooting be necessary.
> ==========================================================
>
> Checking for modem support lines:
> --------------------------------------
> /device/modem symbolic link:
> slmodemd created symbolic link /dev/ttySL0:
> Within /etc/udev/ files:
> /etc/udev/rules.d/77-network.rules:SUBSYSTEM=="net",
> ENV{INTERFACE}=="ppp*|ippp*|isdn*|plip*|lo*|irda*|dummy*|ipsec*|tun*|tap*|bond*|vlan*|modem*|dsl*",
> GOTO="skip_ifup"
> /etc/udev/rules.d/50-udev-default.rules:KERNEL=="mwave", NAME="modems/mwave",
> GROUP="uucp"
> Within /etc/modprobe.conf files:
> /etc/modprobe.conf:# Linux ACP modem (Mwave)
> Within any ancient /etc/devfs files:
>
> Within ancient kernel 2.4.n /etc/module.conf files:
>
> --------- end modem support lines --------
>
