vishud hw:0 is always the audio card, which can support the wvdialconf text, but is incompetent for subsequent COMM. The support (if any) will be through the slam.ko driver. to which I added the recognition codes for 1543:3052. Start with the slmodem-2.9.11-20080417.tar.gz from http://linmodems.technion.ac.il/packages/smartlink/. After the compilation and install the modem will hopefully be activated by # ./slmodemd -c INDIA /dev/slamr0 A first step success would be port creation /dev/ttySL0 --> /dev/pts/N Please report back. For > Class 0703: 1543:3052 Modem: SILICON Laboratories Intel 537 [Winmodem] > Primary device ID: 1543:3052 > Support type needed or chipset: INTEL537_on_1543:3052 the support by slmodemd is Not Certain. Rather yours is an important test case to ascertain whether these 1543:3052 modems can be supported under Linux at all. Note that upon reboot /dev/slamr0 will be gone. Just rerun the # make install to again create the /dev/slamr0 device MarvS scanModem maintainer On Mon, May 19, 2008 at 8:38 AM, Antonio Olivares <olivares14031@xxxxxxxxx> wrote: > vishud, > > scanModem reports: > > Intel 537 > > The output is not clear. There appears to be two > modems and a sharing issue: > >> Modem interrupt assignment and sharing: >> 17: 0 0 IO-APIC-fasteoi >> uhci_hcd:usb3 >> --- Bootup diagnostics for card in PCI slot 04:04.0 >> ---- >> ACPI: PCI Interrupt 0000:04:04.0[A] -> GSI 18 >> (level, low) -> IRQ 17 >> 0000:04:04.0: ttyS1 at I/O 0x1008 (irq = 17) is a >> 16450 >> 0000:04:04.0: ttyS2 at I/O 0x1010 (irq = 17) is a >> 8250 >> 0000:04:04.0: ttyS3 at I/O 0x1018 (irq = 17) is a >> 16450 >> Couldn't register serial port 0000:04:04.0: -28 > > Something does not look right, maybe slmodemd does not > work for this modem and it needs conexant/linuxant > drivers. I'm forwarding this to list so that they > recommend something for you. > > Regards, > > Antonio > > --- vishudh ps <vishudh@xxxxxxxxx> wrote: > >> the command and output are given bellow,what could >> be the problem? >> >> [root@localhost SLMODEMD.gcc4.2]# ./slmodemd -c >> INDIA --alsa hw:0 >> error: mixer setup: Off-hook switch not found for >> card hw:0 >> SmartLink Soft Modem: version 2.9.11 Feb 25 2008 >> 18:25:57 >> symbolic link `/dev/ttySL0' -> `/dev/pts/1' created. >> modem `hw:0' created. TTY is `/dev/pts/1' >> Use `/dev/ttySL0' as modem device, Ctrl+C for >> termination. >> > Only plain text email is forwarded by the >> Discuss@xxxxxxxxxxxxx List Server, >> as HTML can contain viruses. Use as the email >> Subject Line: >> YourName, YourCountry Fedora release 7 >> (Moonshine) >> Kernel kernel 2.6.21-1.3194.fc7 >> With this Subject Line cogent experts will be >> alerted, and useful case names left in the Archive. >> YourCountry will enable Country specific guidance. >> Your contry's local Linux experts >> can be found through: >> http://www.linux.org/groups/index.html. >> They will know your Country's modem code, which may >> be essential for dialup service. >> Responses from Discuss@xxxxxxxxxxxxx are sometimes >> blocked by an Internet Provider mail filters. >> So in a day, also check the Archived responses at >> http://www.linmodems.org >> -------------------------- System information >> ---------------------------- >> CPU=i686, Fedora release 7 (Moonshine) >> Kernel >> Linux version 2.6.21-1.3194.fc7 >> (kojibuilder@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx) (gcc >> version 4.1.2 20070502 (Red Hat 4.1.2-12)) #1 SMP >> Wed May 23 22:35:01 EDT 2007 >> scanModem update of: 2008_05_02 >> >> There are no blacklisted modem drivers in >> /etc/modprobe* files >> USB modems not recognized >> For candidate card in slot 04:04.0, firmware >> information and bootup diagnostics are: >> PCI slot PCI ID SubsystemID Name >> ---------- --------- --------- -------------- >> 04:04.0 1543:3052 1543:3000 Modem: SILICON >> Laboratories Intel 537 [Winmodem] >> >> Modem interrupt assignment and sharing: >> 17: 0 0 IO-APIC-fasteoi >> uhci_hcd:usb3 >> --- Bootup diagnostics for card in PCI slot 04:04.0 >> ---- >> ACPI: PCI Interrupt 0000:04:04.0[A] -> GSI 18 >> (level, low) -> IRQ 17 >> 0000:04:04.0: ttyS1 at I/O 0x1008 (irq = 17) is a >> 16450 >> 0000:04:04.0: ttyS2 at I/O 0x1010 (irq = 17) is a >> 8250 >> 0000:04:04.0: ttyS3 at I/O 0x1018 (irq = 17) is a >> 16450 >> Couldn't register serial port 0000:04:04.0: -28 >> >> For candidate card in slot 00:1b.0, firmware >> information and bootup diagnostics are: >> PCI slot PCI ID SubsystemID Name >> ---------- --------- --------- -------------- >> 00:1b.0 8086:27d8 8086:d605 Audio device: Intel >> Corporation 82801G >> >> Modem interrupt assignment and sharing: >> 22: 5015 1006 IO-APIC-fasteoi HDA >> Intel >> --- Bootup diagnostics for card in PCI slot 00:1b.0 >> ---- >> ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 >> (level, low) -> IRQ 22 >> PCI: Setting latency timer of device 0000:00:1b.0 to >> 64 >> >> >> ===== Advanced Linux Sound Architecture (ALSA) >> diagnostics ===== >> The ALSA packages provide audio support and also >> drivers for some modems. >> ALSA diagnostics are written during bootup to >> /proc/asound/ folders. >> PCI slot 00:1b.0 has a High Definition Audio Card >> >> The ALSA verion is 1.0.14rc2 >> The modem cards detected by "aplay -l" are: >> >> >> The /proc/asound/pcm file reports: >> ----------------------- >> 00-02: ALC883 Analog : ALC883 Analog : capture 2 >> 00-00: ALC883 Analog : ALC883 Analog : playback 1 : >> capture 2 >> >> about /proc/asound/cards: >> ------------------------ >> 0 [Intel ]: HDA-Intel - HDA Intel >> HDA Intel at 0x701c0000 irq 22 >> === Finished firmware and bootup diagnostics, next >> deducing cogent software. === >> >> Predictive diagnostics for card in bus 04:04.0: >> Modem chipset detected on >> CLASS="Class 0703: 1543:3052" >> NAME="Modem: SILICON Laboratories Intel 537 >> [Winmodem] " >> SUBSYS=1543:3000 >> PCIDEV=1543:3052 >> IRQ=17 >> IDENT=INTEL537_on_1543:3052 >> >> For candidate modem in: 04:04.0 >> Class 0703: 1543:3052 Modem: SILICON Laboratories >> Intel 537 [Winmodem] >> Primary device ID: 1543:3052 >> Support type needed or chipset: >> INTEL537_on_1543:3052 >> >> >> ----------------end Softmodem section -------------- >> >> Writing Intel.txt >> >> >> Predictive diagnostics for card in bus 00:1b.0: >> Modem chipset not detected on >> CLASS="Class 0403: 8086:27d8" >> NAME="Audio device: Intel Corporation 82801G " >> SUBSYS=8086:d605 >> PCIDEV=8086:27d8 >> IRQ=22 >> HDA=8086:27d8 >> SOFT=8086:27d8.HDA >> >> >> High Definition Audio (HDA) cards MAY host a modem >> chip in their Subsystem, >> and many are supported by the ALSA audio+modem >> driver snd-hda-intel >> A modem was not detected on HDA card 8086:27d8. >> If another modem card is present, then most likely >> 8086:27d8 does not host a modem. >> If another modem card has not been detected, then >> possibilities are: >> 1) A Conexant modem chip is present on 8086:27d8, >> as Conexant chips >> are frequently not detectable by ALSA diagnostics >> 2) The modem may be of the older non-PCI Controller >> Chipset (hardware) type. >> Try detection with Root permission: >> wvdialconf /etc/wvdial.conf >> >> For candidate modem in: 00:1b.0 >> Class 0403: 8086:27d8 Audio device: Intel >> Corporation 82801G >> Primary device ID: 8086:27d8 >> Subsystem PCI_id 8086:d605 >> Softmodem codec or chipset from diagnostics: >> from Archives: >> >> >> >> Support type needed or chipset: >> >> Support can likely be achieved through two mutually >> exclusive alternatives: >> 1) The hsfmodem software for Conexant chipset >> modems: Read Conexant.txt >> The following ALSA alternative CANNOT work with >> Conexant modems. >> >> 2) An ALSA modem driver plus slmodemd. Read >> Smartlink.txt for details, and >> to test get the package SLMODEMD.gcc4.1.tar.gz from: >> >> http://linmodems.technion.ac.il/packages/smartlink/ >> >> ----------------end Softmodem section -------------- >> Writing Smartlink.txt >> ============ end Smartlink section >> ===================== >> >> Completed candidate modem analyses. >> >> The base of the UDEV device file system is: >> /dev/.udev >> >> Versions adequately match for the compiler >> installed: 4.1.2 >> and the compiler used in kernel >> assembly: 4.1.2 >> >> >> >> Minimal compiling resources appear complete: >> make utility - /usr/bin/make >> Compiler version 4.1 >> linuc_headers base folder >> /lib/modules/2.6.21-1.3194.fc7/build >> >> However some compilations and executable functions >> may need additional files, >> in the FileNames.h (so called kernel "h"eaders) >> collection installed in /usr/include/ . >> For martian_modem, additional required packages are >> libc6-dev > === message truncated === > > > > >
