Craig, under Ubuntu 2.6.22-14-generic, for modem PCI slot PCI ID SubsystemID Name ---------- --------- --------- -------------- 00:0a.0 11c1:0620 11c1:0621 Communication controller: Agere Systems All you have done seems OK, and a few others have the same problem. Effectiveness for the agrsm package seems to be broken in the 2.6.22 kernel series. Perhaps install a Feisty 2.6.20 kernel package and complementary linux-headers, to compile and test drivers thereunder. The Feisty kernels are competent in the Gutsy "background". If thereis no responsive thereunder, the next step would be to additionally install a 2.6.18 series kernel package + headers. With it you could additionally try try from http://phep2.technion.ac.il/linmodems/packages/ltmodem/sv92/ the suse-10-2a.tar.gz which has newer code from LSI (formerly Agere) in the pre-compiled component, but is only competent upto 2.6.18 Alan Hendrickson is tracking these packages. If you can get service under 2.6.18 or 20, your System can serve as a test bed for workup to more current kernels. MarvS scanModem maintainer http://phep2.technion.ac.il/linmodems/packages/ltmodem/sv92/ On Dec 24, 2007 3:24 AM, Craig Van Degrift <craig@xxxxxxxxxxxxxxxxxxxxx> wrote: > Trying to setup Walmart Everex TC2502 and need dialup. > Using Ubuntu Gutsy with 2.6.22-14-generic > ModemData.txt attached. > > Compiled agrsm-20070804.tar.gz after patching according to > http://linmodems.technion.ac.il/bigarch/archive-seventh/msg02114.html > > Added /etc/udev/rules.d/10-local.rules containing > KERNEL=="ttyAGS3", SYMLINK+="modem" > KERNEL=="ttyAGS3", SYMLINK+="ttySAGS3" > > Appended agrserial to /etc/modules and confirmed agrserial and agrmodem loaded > upon reboot with desired links to modem and ttySAGS3. > > wvdialconf /etc/wvdial.conf failed with "Sorry, no modem was detected!" > message after trying 2400, 9600, and 115200 baud on ttySAGS3<*1>. > > setserial -agv /dev/ttyAGS3 produces > /dev/ttyAGS3, Line 3, UART: 16550A, Port: 0xd000, IRQ: 10 > Baud_base: 115200, close_delay: 50, divisor: 0 > Flags: spd_normal > > sudo lspci -v shows: > Communications controller: Agere Systems Unknown device 0620 > Subsystem: Agere Systems Unknown device 0621 > Flags: medium devsel, IRQ 18 > I/O ports at d000 [size=256] > Capabilities: [f8] Power Management version 3 > > Note lspci shows different IRQ than setserial, but if use setserial to set IRQ > to 18, still no success with wvdialconf. > > Tried with boot parameter acpi=off, but same result. > > Suggestions?? >
