Hi, I used scanModem on my pc and the result is attached...
If you cannot answer before tomorrow morning, I won't be able to test your commands, because I'm leaving at 12:00 (Italian time).
Anyway I'll be home once again in Christmas time, so I'll test then your suggestions.
Thanks,
Francesco from Italy
------------------------------------------------------
Leggi GRATIS le tue mail con il telefonino i-mode? di Wind
http://i-mode.wind.it/
The files in this Modem/ folder have the following roles:
ModemData.txt - Diagnostics and accumulated information cogent to your modem and host system.
This is the ONLY file which should be sent to the List DISCUSS@xxxxxxxxxxxxx ,
if further help is needed. Send your email and attachments as plain text as
other formats are rejected by the List Server, to avoid virus transmission.
Always send the ENTIRE ModemData.txt, as It includes subtle diagnostic ouputs needed
to best guide you. Please in the covering email mention your Country, to enable Country
specific advice.
Always use the most recent update of scanModem accessed ONLY at
http://linmodems.technion.ac.il/packages/scanModem.gz
to produce ModemData.txt
URLs to cogent advice are regularly updated, so your problem may be solved therein.
Please Do NOT send Do NOT send other files in this folder Modem/
A file(s) specific to your modem chipset will be written, such as:
Smartlink.txt, Conexant.txt, Intel.txt , etc
YourModem.txt - Guidance about operating your particular System, for your benefit
It should NOT be sent to Discuss@xxxxxxxxxxxxx
Rational.txt - Motivations of this scanModem package.
DriverCompiling.txt - Explains the roles of additional files which may have to be installed
to support compiling of modem drivers, and the steps to take.
SoftModem.txt - Information and instructions about "soft modems".
For these modems, additional steps may be necessary for choice of supporting software.
The primary PCI ID is that of the host audio or modem controller, which can support diverse Subsystems. It is the chipset of the Subsystem which determines the software needed.
ModemTesting.txt SHOULD be read, but after drivers have been installed.
InfoGeneral.txt has general information about the status of winmodem support under Linux,
Do read it if ModemData.txt reports that your current modem is not supported under Linux.
Unsubscribe.txt - Howto terminate email tranmissions from the List.
If you are Linux newcomer, please do locate your local Linux group through:
http://www.linux.org/groups/index.html . If you are not comfortable with English,
a local Linux user can often be of substantial assistance in getting you on to the Internet.
Only plain text email is forwarded by the DISCUSS@xxxxxxxxxxxxx List Server.
Do use the following as the email Subject Line:
SomeName, YourCountry
Welcome to openSUSE 10.2 (i586) - Kernel kernel 2.6.18.2-34-default
This will alert cogent experts, and distinguish cases in the Archives.
YourCountry will enable Country Code guidance.
Occassionally responses are blocked by an Internet Provider mail filters.
So in a day, also check the Archived responses at http://www.linmodems.org .
Local Linux experts can be found through: http://www.linux.org/groups/index.html
-------------------------- System information ----------------------------
CPU=i686,
Welcome to openSUSE 10.2 (i586) - Kernel
Linux version 2.6.18.2-34-default (geeko@buildhost) (gcc version 4.1.2 20061115 (prerelease) (SUSE Linux)) #1 SMP Mon Nov 27 11:46:27 UTC 2006
scanModem update of: 2007_Sept_24
There are no blacklisted modem drivers in /etc/modprobe* files
USB modem not detected by lsusb
Several modems are supported by drivers with ALSA, the Advanced Linux Sound Architecture software.
Copying ALSA diagnostics to Modem/ALSAroot.tgz
ALSAversion = 1.0.13
Modem or candidate host audio card have firmware information and diagnostics:
PCI slot PCI ID SubsystemID Name
---------- --------- --------- --------------
00:09.0 1057:3052 1057:3020 Modem: Motorola Unknown device 3052
Modem interrupt assignment and sharing:
11: 3 XT-PIC uhci_hcd:usb2, ohci1394, eth0
--- Bootup diagnostics for card in PCI slot 00:09.0 ----
ACPI: PCI Interrupt 0000:00:09.0[A] -> Link [LNKC] -> GSI 11 (level, low) -> IRQ 11
0000:00:09.0: ttyS2 at I/O 0xc808 (irq = 11) is a 16450
0000:00:09.0: ttyS3 at I/O 0xc810 (irq = 11) is a 8250
Couldn't register serial port 0000:00:09.0: -28
=== Finished modem firmware and bootup diagnostics section. ===
=== Next deducing cogent software ===
For candidate modem in PCI bus: 00:09.0
Class 0703: 1057:3052 Modem: Motorola Unknown device 3052
Primary PCI_id 1057:3052
Support type needed or chipset: slamr
1057:3052 has a Motorola chipset, poorly supported by Motorola itself
However Zello discovered that drivers written to support Smartlink modems do support the 1057:3052 chipset!!
It sufficed to add 1057:3052 to the list of modem cards recognized by the Smartlink slamr driver.
There is a ungrab-winmodem driver used in conjunction with slamr, which must have 1057:3052
similarly added. See messages from Zello:
http://linmodems.technion.ac.il/bigarch/archive-seventh/msg00846.html
http://linmodems.technion.ac.il/bigarch/archive-seventh/msg00848.html
and Alvaro Aguirre about the ungrab-winmodem fix:
http://linmodems.technion.ac.il/bigarch/archive-seventh/msg00990.html
For general guidance on ungrab-winmodem + slamr usage, read the Smartlink.txt
The modem is supported by the Smartlink slamr driver
plus the slmodemd helper utility. Read the
Smartlink.txt and Modem/YourSystem.txt for follow through guidance.
Writing Smartlink.txt
============ end Smartlink section =====================
Completed candidate modem analyses.
The base of the UDEV device file system is: /dev/.udev
Versions adequately match for the compiler installed: 4.1.2
and the compiler used in kernel assembly: 4.1.2
linux-headers-2.6.18.2-34-default resources needed for compiling are not manifestly ready!
If compiling is necessary packages must be installed, providing:
kernel-source-2.6.18.2-34-default
If a driver compilation files with message including some lack of some FileName.h (stdio.h for example.
Some additional kernel-header files need installation to /usr/include.
For Debian/Ubuntu related distributions, run the following command to display the needed package list:
$ sudo apt-get -s install linux-kernel-devel
While some of the files may be on the install CD, others may have to be found through http://packages.ubuntu.com
For Ubuntu Feisty, additional packages required were:
libc6-dev linux-libc-dev
available through http://packages.ubuntu.com/ , if not on the install CD.
Such packages may have different names for other Linux distributions.
Try installing just the libc6-dev, then test the compile again.
Checking pppd properties:
-rwxr-xr-x 1 root dialout 295488 25 nov 2006 /usr/sbin/pppd
In case of an "error 17" "serial loopback" problem, see:
http://phep2.technion.ac.il/linmodems/archive-sixth/msg02637.html
To enable dialout without Root permission do:
$ su - root (not for Ubuntu)
chmod a+x /usr/sbin/pppd
or under Ubuntu related Linuxes
chmod a+x /usr/sbin/pppd
Checking settings of: /etc/ppp/options
noipdefault
noauth
crtscts
lock
modem
asyncmap 0
nodetach
lcp-echo-interval 30
lcp-echo-failure 4
lcp-max-configure 60
lcp-restart 2
idle 600
noipx
file /etc/ppp/filters
In case of a message like:
Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html
Read Modem/YourSystem.txt concerning other COMM channels: eth0
Which can interfere with Browser naviagation.
Don't worry about the following, it is for the experts
should trouble shooting be necessary.
==========================================================
Checking for modem support lines:
--------------------------------------
/device/modem symbolic link:
slmodemd created symbolic link /dev/ttySL0:
Within /etc/udev/ files:
/etc/udev/rules.d/31-network.rules:SUBSYSTEM=="net", ENV{INTERFACE}=="ppp*|ippp*|isdn*|plip*|lo*|irda*|dummy*|ipsec*|tun*|tap*|bond*|vlan*|modem*|dsl*", GOTO="skip_ifup"
/etc/udev/rules.d/50-udev-default.rules:KERNEL=="mwave", NAME="modems/%k", GROUP="uucp"
Within /etc/modprobe.conf files:
/etc/modprobe.conf:# Linux ACP modem (Mwave)
/etc/modprobe.d/blacklist:# ALSA PCI sound/modem modules - should be configured via yast
/etc/modprobe.d/blacklist:blacklist snd-atiixp-modem
/etc/modprobe.d/blacklist:blacklist snd-via82xx-modem
Within any ancient /etc/devfs files:
Within ancient kernel 2.4.n /etc/module.conf files:
--------- end modem support lines --------
