I bought a CX11252-11 modem used it with registered linuxant driver; it will only connect using V.34. It's supposed to be a V.92 modem. Anybody knows how to get it to work right ? AT#UG <#UG VERSION=3> <DRIVER VERSION=hsfmodem-7.60.00.02full> <CALL SETUP RESULT=Detected Data Answer Tone> <MULTIMEDIA MODE=Data Only> <DTE-DCE MODE=Async data> <V.8 CM=""> <V.8 JM=""> <RX SIG PWR DB=0, TX SIG PWR DB=0, S/N RATIO DB=0> <RTD=-3> <TX MOD=V.34, TX SYMBOL RATE=3429, TX CARRIER FREQ=0> <RX MOD=V.34, RX SYMBOL RATE=3429, RX CARRIER FREQ=0> <TX FIRST RATE=16800, RX FIRST RATE=32000> <CARRIER LOSS=0, RATE RENEG=4> <RETRAINS REQ=0, RETRAINS DET=2> <TX FINAL RATE=16800, RX FINAL RATE=31200> <PROTOCOL=LAPM> <EC FRAME SIZE=100> <EC LINK TIMEOUTS=0> <EC LINK NAKS=0> <COMPRESSION=V44> <COMPRESSION DICTIONARY SIZE=800> <TX FLOW CONTROL=0> <RX FLOW CONTROL=0> <TX CHARS SENT FROM DTE=223> <RX CHARS SENT TO DTE=A50> <TX CHARS LOST=0> <RX CHARS LOST=0> <TX FRAME COUNT=B> <RX FRAME COUNT=C> <TX FRAME ERROR COUNT=2> <RX FRAME ERROR COUNT=0> <TERMINATION CAUSE=DTR drop> <CALL WAITING EVENT COUNT=0> <LSD Vdd=0, Power Bits=0> <V8BIS DSP VER=0> <RATE RENEG REQ=0, RATE RENEG DET=4> <RBS=0, AltRBS=0> <DIG PAD DET=0, DIG LOSS EST=0, IMD RATIO=0, SPEED DROP=0> <HS CNT=0, Det1=0, Res1=140, LAPM=5> <EQM=0, TRAINING EQM=0> <HandShake Time=42.808> <DIB ERROR COUNTERS=0, 0, 0, 0, 0, 0, 0, 0> OK