paul trader, usa, ubuntu 6.10, kernel 2.6.17-11-generic

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




hi list - i have the 0x11c11040 softmodem chip made by agere. i downloaded the 1.014rc2 drivers, compiled, installed, and rebooted. when i run scanModem again, it still seems to be using the old version (1.0.11). see below for ModemData.txt. this modem is so close to functioning, i can send an atz in minicom, but when i send an atdt command it immediately responds with 'no carrier'.

regards, paul


-------------------------- System information ----------------------------
CPU=i686,  Ubuntu 6.10
Linux version 2.6.17-11-generic (root@terranova) (gcc version 4.1.2 20060928 (prerelease) (Ubuntu 4.1.1-13ubuntu5)) #2 SMP Thu Feb 1 19:52:28 UTC 2007 (Ubuntu 2.6.17-11.35-generic)
 scanModem update of:  2007_Feb_09


USB modem not detected by lsusb

Modem or host audio card candidates have firmware information:

 PCI slot       PCI ID          SubsystemID     Name
 ----------     ---------       ---------       --------------
00:1b.0 8086:27d8 14c0:0017 Audio device: Intel Corporation 82801G

 Modem interrupt assignment and sharing:
 66:        807          0   IO-APIC-level  HDA Intel

 --- Bootup diagnositcs for card in PCI slot 00:1b.0 ----
[17179585.084000] ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 66
[17179585.084000] PCI: Setting latency timer of device 0000:00:1b.0 to 64

 === Finished modem firmware and bootup diagnostics section. ===
 === Next deducing cogent software ===

ALSAversion 1.0.11
8086:27d8 is a High Definition Audio card, possibly hosting a soft modem.


The VendorID 0x11c11040 softmodem chip is in principle supported by the snd-hda-intel driver included within the ALSA audio+modem driver set. However recognition of 0x11c11040 first begins with ALSA version 1.0.14rc2. There are instructions for upgrading snd-hda-intel and its dependent driver set at http://linmodems.technion.ac.il/archive-sixth/msg05023.html The ? in the device designation in hw:0,? will be manifest after the driver update.
Typically ? is in the range of 0-6 .


There may be novel modem chipset information within the /proc/asound/
files. They have been copied and packed into a file: Modem/11c1.tgz
Please send 11c1.tgz to the scanModem maintainer: Marvin.Stodolsky@xxxxxxxxx

 For candidate modem in PCI bus:  00:1b.0
   Class 0403: 8086:27d8 Audio device: Intel Corporation 82801G
      Primary PCI_id  8086:27d8
    Subsystem PCI_id  14c0:0017
Softmodem codec or Vendor from diagnostics: 11c1, an AgereSystems type.
                              from    Archives:


 This is a NEW softmodem case!  Please send the output ModemData.txt
 to DISCUSS@xxxxxxxxxxxxx , even if further assistance is not needed.
 It will enrich the Archive and help others!
 -------------------------------------------
 Lacking a dsp (digital signal processing) chip, the modem is a software
 intensive or "softmodem" type. Its primary controller manages the traffic
 with the CPU. But the software needed is specified in the Subsystem.
 -----------------------------------------
Support type needed or chipset: slmodemd

 An ALSA (Advanced Linux Sound Architecture) modem driver:  snd-hda-intel
 provides Low Level support enabling contact with the modem hardware.
 For all BUT Conexant chip soft modems (using hsfmodem software)
complementary High Level support is through a Smartlink utility: slmodemd

 Download from http://linmodems.technion.ac.il/packages/smartlink/
the package SLMODEMD.gcc4.tar.gz having a compiled slmodemd. Unpack under Linux with:
        $ tar zxf SLMODEMD.gcc4.tar.gz
and read instructions therein. But briefly, the modem is setup with command:
        sudo slmodemd -c YOUR_COUNTRY --alsa hw:0,6
 reporting dynamic creation of ports:
        /dev/ttySL0 --> /dev/pts/N   , with N some number
 Read Smartlink.txt and Modem/YourSystem.txt for follow through guidance.

Already loaded into the kernel is snd-hda-intel and audio drivers it depends on,
 displayed by:  lsmod | grep snd_hda_intel
Module                  Size  Used by
-------------------------------------
snd_hda_intel          22936  1
snd_hda_codec         209792  1 snd_hda_intel
snd_pcm                85764  3 snd_hda_intel,snd_hda_codec,snd_pcm_oss
snd 62984 8 snd_hda_intel,snd_hda_codec,snd_pcm_oss,snd_mixer_oss,snd_pcm,snd_timer
snd_page_alloc         11656  2 snd_hda_intel,snd_pcm


The diagnostic outputs for this softmodem section have their raw information in folders and text files under /proc/asound/ which you can browse. The information
is from files:
        /proc/asound/pcm
-------------------------------
00-06: Si3054 Modem : Si3054 Modem : playback 1 : capture 1
00-02: ALC883 Analog : ALC883 Analog : capture 2
00-01: ALC883 Digital : ALC883 Digital : playback 1
00-00: ALC883 Analog : ALC883 Analog : playback 1 : capture 2

        /proc/asound/modules
-------------------------------
 0 snd_hda_intel
        /proc/asound/card0/codec#1
-------------------------------
Codec: Generic 11c1 Si3054
Address: 1
Vendor Id: 0x11c11040
Subsystem Id: 0x11c10001
Revision Id: 0x100200
-------------------------------
Current support status of HDA cards is:
  Vendor IDs  Chip maker     Support type
  ----------  ----------    -------------
  0x14f12bfa  Conexant      hsfmodem , not slmodemd compatible
  0x11c13026  AgereSystems  snd-hda-intel, slmodemd supported
  0x11c11040  AgereSystems      "             "    , patch needed
  0x11c13055  AgereSystems      "             "    ,      "
  0x163c3055  Smartlink         "             "    ,      "
  0x163c3155    "               "             "    ,      "
  0x10573055  Motorola          "             "    ,      "
  0x10573155     "              "             "    ,      ""
as of October 2006.

and from the command:
        aplay -l | grep -i modem
card 0: Intel [HDA Intel], device 6: Si3054 Modem [Si3054 Modem]

----------------end Softmodem section --------------

Writing Intel.txt
Writing Smartlink.txt
============ end Smartlink section =====================

 Completed candidate modem analyses.

 The base of the UDEV device file system is: /dev/.udev

 Versions adequately match for the compiler installed: 4.1.2
             and the compiler used in kernel assembly: 4.1.2



 Compiling resources appear complete:
   make utility - /usr/bin/make
   Compiler version 4.1
   kernel_headers base folder /lib/modules/2.6.17-11-generic/build
Compressed files at: /usr/src/linux-source-2.6.17.tar.bz2


Checking pppd properties:
        -rwsr-xr-- 1 root dip 260920 2006-07-10 15:13 /usr/sbin/pppd

In case of an "error 17" "serial loopback" problem, see:
    http://phep2.technion.ac.il/linmodems/archive-sixth/msg02637.html

To enable dialout without Root permission do:
        $ su - root  (not for Ubuntu)
        sudo chmod a+x /usr/sbin/pppd
or under Ubuntu related Linuxes
        sudo chmod a+x /usr/sbin/pppd

Checking settings of:   /etc/ppp/options
asyncmap 0
auth
crtscts
lock
hide-password
modem
proxyarp
lcp-echo-interval 30
lcp-echo-failure 4
noipx
In case of a message like:
   Warning: Could not modify /etc/ppp/pap-secrets: Permission denied
see http://linmodems.technion.ac.il/bigarch/archive-sixth/msg04656.html

Read Modem/YourSystem.txt concerning other COMM channels: eth0 eth1
Which can interfere with Browser naviagation.

 Don't worry about the following, it is for the experts
 should trouble shooting be necessary.
==========================================================

# start/stop the daemon when the USB modem is connected
KERNEL=="slusb[0-9]*", GROUP="dialout", RUN+="/etc/init.d/sl-modem-daemon"
 Checking for modem support lines:
 --------------------------------------
     /device/modem symbolic link:
slmodemd created symbolic link /dev/ttySL0:
     Within /etc/udev/ files:
/etc/udev/rules.d/60-symlinks.rules:# Create /dev/modem symlink
/etc/udev/rules.d/60-symlinks.rules:KERNEL=="ttyLTM[0-9]*", SYMLINK+="modem" /etc/udev/rules.d/030_sl-modem-daemon.rules:# start/stop the daemon when the USB modem is connected /etc/udev/rules.d/030_sl-modem-daemon.rules:KERNEL=="slusb[0-9]*", GROUP="dialout", RUN+="/etc/init.d/sl-modem-daemon" /etc/udev/sl-modem-daemon.rules:# start/stop the daemon when the USB modem is connected /etc/udev/sl-modem-daemon.rules:KERNEL=="slusb[0-9]*", GROUP="dialout", RUN+="/etc/init.d/sl-modem-daemon"
     Within /etc/modprobe.conf files:
/etc/modprobe.d/alsa-base:options snd-atiixp-modem index=-2
/etc/modprobe.d/alsa-base:options snd-via82xx-modem index=-2
/etc/modprobe.d/blacklist-modem:# Uncomment these entries in order to blacklist unwanted modem drivers
/etc/modprobe.d/blacklist-modem:# blacklist snd-atiixp-modem
/etc/modprobe.d/blacklist-modem:# blacklist snd-via82xx-modem
/etc/modprobe.d/sl-modem-daemon.modutils:install slamr modprobe --ignore-install ungrab-winmodem ; modprobe --ignore-install slamr; test -e /dev/slamr0 || (/bin/mknod -m 660 /dev/slamr0 c 242 0 2>/dev/null && chgrp dialout /dev/slamr0)
     Within any ancient /etc/devfs files:

     Within ancient kernel 2.4.n /etc/module.conf files:

--------- end modem support lines --------


[Index of Archives]     [Linux Media Development]     [Asterisk]     [DCCP]     [Netdev]     [X.org]     [Xfree86]     [Fedora Women]     [Linux USB]

  Powered by Linux