Hi all, I have a multihomed system (very similar to the one described in LARTC HowTo Section 4.2. Routing for multiple uplinks/providers) with IPv6 addresses. I want to create a routing table per interface to be able to route the traffic depending on the source address using IPv6 addresses and dynamic gateways. How do I set the default gateway to be dynamic in a separate routing table? My current configuration is: IF_1: Interface 1 SUBNET_1: the subnet connected to Interface 1 IPv6_1: IPv6 address configured on Interface 1 T_1: Routing table for Interface 1 IF_2: Interface 2 SUBNET_2: the subnet connected to Interface 2 IPv6_2: IPv6 address configured on Interface 2 T_2: Routing table for Interface 2 Configuration: ip -6 route add $SUBNET_1 dev $IF_1 table $T_1 ip -6 rule add from $IPv6_1 table $T_1 I am clearly missing one route, that should look like: ip -6 route add default via <GATEWAY_1> tab $T_1 How should I set this route to use the dynamically obtained gateway? The dynamic gateways are listed in the "default" routing table as: % ip -6 route show default default via DYNAMIC_GWv6_1 dev IF_1 proto kernel metric .... default via DYNAMIC_GWv6_2 dev IF_2 proto kernel metric .... The order in which these routes are listed is arbitrary (restarting /etc/init.d/networking re-shuffles them). Is there a way to ensure that a packet being sent from IPv6_1 goes out via the correct gateway (DYNAMIC_GWv6_1) and interface (IF_1)? Many thanks in advance for any help. Adrian -- To unsubscribe from this list: send the line "unsubscribe lartc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
