On 05/31/07 07:22, William Bohannan wrote:
Thanks Grant, I am very new to combining NATing and Brigdge. Please can you possibly give an example on how to add the virtual interface.
I'll try. I don't recognize the format of the file below, but I'll take a stab at it.
Current /etc/networking/interfaces looks like this: --------------------------------------- auto lo iface lo inet loopback auto br0 iface br0 inet static address xxx.xxx.xxx.xxx netmask 255.255.255.128 network xxx.xxx.xxx.xxx broadcast xxx.xxx.xxx.xxx gateway xxx.xxx.xxx.xxx
auto br0:1 iface br0:1 inet static address xxx.xxx.xxx.xxx netmask 255.255.255.128 network xxx.xxx.xxx.xxx broadcast xxx.xxx.xxx.xxx gateway xxx.xxx.xxx.xxx
pre-up /sbin/ip link set eth0 up pre-up /sbin/ip link set eth1 up pre-up /usr/sbin/brctl addbr br0 pre-up /usr/sbin/brctl addif br0 eth0 pre-up /usr/sbin/brctl addif br0 eth1 -----------------------------------------
Again this is just a guess and where I would start. You may have better luck seeking support through your distribution.
Grant. . . . _______________________________________________ LARTC mailing list LARTC@xxxxxxxxxxxxxxx http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
