|
I have a connection cablemodem (down 1024kbit up
256 kbit) that spreads Internet to a LAN of 4 PC. Router-firewall is one
486 DX4 100 96 MB RAM that runs a Debian Sarge (kernel 2,4,25), that does NOT
serve nor squid, nor samba, nor smtp, etc.... single
do routing-firewalling.
I am something confused by opinions and "presumed"
manual and howto that I have read and have confused I more... Then I ask
to them you:
I must do shaping with the NIC that connect with
ISP (etho)... or with the NIC of the LAN (eth1)????... Because I
have seen opinions on both possibilities, but I have tested the two and second
did not give me good results. In the case of using the NIC to
Internet (eth0) I must set like CEIL the bandwidth of downstream (1024kbit) or
upstream (256kbit)????... And in such case I must set the 75 percent
approximately of the bandwidth to avoid to saturate the band?
Another question is if it agrees -upon my
case- using priorities for the classes...
Thanks in advance
Ricardo
|
_______________________________________________ LARTC mailing list LARTC@xxxxxxxxxxxxxxx http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
