RaÃl Alexis Betancort Santana wrote:
Hi all, i'm new at LARTC, and after reading the docs I found no solution to my
problem ...
On one side I have eth0 conected to the LAN, on the other side I have eth1
conected to a switch and to 3 DSL routers with 3 diferent providers, and also
eth2 conected to a cisco 2600 conected to a LDMS line.
I have readed the larct docs about multihomed conections to internet, but I'm
been unable to setup the routes with iproute2. I have setup a default
multihop route, but if I receive a ssh conection throught one of the DSL
lines it get not answered by the same line, it's answered throught the
default route, How could I change this? I want to begin by answering the
traffic by the line it is coming in.
Well. this should be done automatically otherwise it would break TCP/ip. I think you messed
up your config.
Mine setup with 2 ip's:
rasnet:/etc/blootbot# ip rule
0: from all lookup local
32760: from all to 213.226.172.0/24 lookup parabole
32761: from all to 213.252.224.0/24 lookup parabole
32763: from all to 213.226.161.0/24 lookup parabole
32764: from all to 213.226.147.0/24 lookup parabole
32765: from all to 213.226.146.0/24 lookup parabole
32766: from all lookup main
32767: from all lookup default
rasnet:/etc/blootbot# ip route
192.168.20.0/24 dev eth1 proto kernel scope link src 192.168.20.59
192.168.0.0/24 dev eth0 proto kernel scope link src 192.168.0.1
81.0.0.0/8 dev eth0 proto kernel scope link src 81.7.84.36
default via 81.7.84.1 dev eth0 src 81.7.84.36
rasnet:/etc/blootbot# ip route ls table parabole
default via 192.168.20.1 dev eth1
_______________________________________________
LARTC mailing list / LARTC@xxxxxxxxxxxxxxx
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
