Hi All, I am trying to understand how to setup routing for multiple uplinks using a Bering firewall. Using this document http://lartc.org/howto/lartc.rpdb.multiple-links.html 1) Am I correct in that I can safely leave out these commands, since these routes are automatically setup by Bering? ip route add $P1_NET dev $IF1 src $IP1 ip route add $P2_NET dev $IF2 src $IP2 2) I am also struggling to understand which of the commands are responsible for ensuring that packets arriving on one interface, are equally returned on the same interface. Is it achieved by this? ip rule add from $IP1 table T1 ip rule add from $IP2 table T2 or this? ip route add $P0_NET dev $IF0 table T1 ip route add $P2_NET dev $IF2 table T1 ip route add 127.0.0.0/8 dev lo table T1 ip route add $P0_NET dev $IF0 table T2 ip route add $P1_NET dev $IF1 table T2 ip route add 127.0.0.0/8 dev lo table T2 Regards, Simon Chalk. _______________________________________________ LARTC mailing list / LARTC@xxxxxxxxxxxxxxx http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/