On Mon, 9 Dec 2002, Thomas Jalsovsky wrote: > On Mon, 9 Dec 2002, Vladimir Smelhaus wrote: > > > On 9 Dec 2002, 15:52, Thomas Jalsovsky wrote: > > > > > I have HTB on IMQ device. My rate does not work as I configured. I > > > configured 1920kbit/s and I can download only about 290kbit/s (while > > > > Set your pfifo limit higher. You have too much dropped packets. > > > > > class htb 1:10 parent 1:1 leaf 10: prio 0 quantum 9011 rate 704Kbit > > > ceil 1920Kbit burst 2500b/8 mpu 0b cburst 4056b/8 mpu 0b level 0 > > > Sent 8642235 bytes 8393 pkts (dropped 2153, overlimits 0) > > > rate 36918bps 36pps > > > lended: 3618 borrowed: 4775 giants: 0 > I have: > ifconfig imq0 > imq0 Link encap:UNSPEC HWaddr > 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00 > UP RUNNING NOARP MTU:1500 Metric:1 > RX packets:821349 errors:0 dropped:0 overruns:0 frame:0 > TX packets:723509 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:30 > RX bytes:456249915 (435.1 Mb) TX bytes:391405155 (373.2 Mb) > > Which value if txqueuelen should be good for me? Or you though for > anything else (in lartc pfifo limit is txqueuelen..) Sorry, it was my mistake, I had limit 2 in my configuration. Now I have the default - 30p - and it works fine for me. Thank you for your help. Regards, Thomas _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
