On Monday 05 April 2010 22.04:17 Held Bernhard wrote: > Hi Dan! > > > This should be done over the host-eth3 interface and I have set up the > > br-eth3 and qtap3 the same way as with the eth1/br-eth1/qtap1 with one > > difference - the br-eth3 interface is setup without an IP. > > When doing traffic from the VM to the network I can see traffic on the > > qtap3 and br-eth3 interface but none on the eth3. > > > > Must I specify an IP for the br-eth3 interface? > > No, an IP is not required. Just activate br-eth3 and don't forget to add > a route: > > ifconfig br-eth3 up 0.0.0.0 > route add 192.168.3.0 netmask 255.255.255.0 eth3 Hi All, A big THANKS to all of you - I finally got it to work. I must have messed up something on the Host when I was trying. After a reboot of the Host and then creating the br-???, qtap? and so on again it started working. Once again - THANKS! -- Dan Johansson, <http://www.dmj.nu> *************************************************** This message is printed on 100% recycled electrons! *************************************************** -- To unsubscribe from this list: send the line "unsubscribe kvm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
