[PATCH] KVM: arm64: timers: Use CNTHCTL_EL2 when setting non-CNTKCTL_EL1 bits

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



It recently appeared that, whien running VHE, there is a notable
difference between using CNTKCTL_EL1 and CNTHCTL_EL2, despite what
the architecture documents:

- When accessed from EL2, bits [19:18] and [16:10] same bits have
  the same assignment as CNTHCTL_EL2
- When accessed from EL1, bits [19:18] and [16:10] are RES0

It is all OK, until you factor in NV, where the EL2 guest runs at EL1.
In this configuration, CNTKCTL_EL11 doesn't trap, nor ends up in
the VNCR page. This means that any write from the guest affecting
CNTHCTL_EL2 using CNTKCTL_EL1 ends up losing some state. Not good.

The fix it obvious: don't use CNTKCTL_EL1 if you want to change bits
that are not part of the EL1 definition of CNTKCTL_EL1, and use
CNTHCTL_EL2 instead. This doesn't change anything for a bare-metal OS,
and fixes it when running under NV. The NV hypervisor will itself
have to work harder to merge the two accessors.

Note that there is a pending update to the architecture to address
this issue by making the affected bits UNKNOWN when CNTKCTL_EL1 is
user from EL2 with VHE enabled.

Fixes: c605ee245097 ("KVM: arm64: timers: Allow physical offset without CNTPOFF_EL2")
Signed-off-by: Marc Zyngier <maz@xxxxxxxxxx>
Cc: stable@xxxxxxxxxxxxxxx # v6.4
---
 arch/arm64/kvm/arch_timer.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/kvm/arch_timer.c b/arch/arm64/kvm/arch_timer.c
index 0696732fa38c..6dcdae4d38cb 100644
--- a/arch/arm64/kvm/arch_timer.c
+++ b/arch/arm64/kvm/arch_timer.c
@@ -827,8 +827,8 @@ static void timer_set_traps(struct kvm_vcpu *vcpu, struct timer_map *map)
 	assign_clear_set_bit(tpt, CNTHCTL_EL1PCEN << 10, set, clr);
 	assign_clear_set_bit(tpc, CNTHCTL_EL1PCTEN << 10, set, clr);
 
-	/* This only happens on VHE, so use the CNTKCTL_EL1 accessor */
-	sysreg_clear_set(cntkctl_el1, clr, set);
+	/* This only happens on VHE, so use the CNTHCTL_EL2 accessor. */
+	sysreg_clear_set(cnthctl_el2, clr, set);
 }
 
 void kvm_timer_vcpu_load(struct kvm_vcpu *vcpu)
@@ -1563,7 +1563,7 @@ int kvm_timer_enable(struct kvm_vcpu *vcpu)
 void kvm_timer_init_vhe(void)
 {
 	if (cpus_have_final_cap(ARM64_HAS_ECV_CNTPOFF))
-		sysreg_clear_set(cntkctl_el1, 0, CNTHCTL_ECV);
+		sysreg_clear_set(cnthctl_el2, 0, CNTHCTL_ECV);
 }
 
 int kvm_arm_timer_set_attr(struct kvm_vcpu *vcpu, struct kvm_device_attr *attr)
-- 
2.34.1




[Index of Archives]     [KVM ARM]     [KVM ia64]     [KVM ppc]     [Virtualization Tools]     [Spice Development]     [Libvirt]     [Libvirt Users]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite Questions]     [Linux Kernel]     [Linux SCSI]     [XFree86]

  Powered by Linux