On 4/4/23 17:48, Michael Roth wrote:
On Fri, Feb 24, 2023 at 01:37:48PM +0100, Alexander Graf wrote:
On 20.02.23 19:38, Michael Roth wrote:
From: Tom Lendacky <thomas.lendacky@xxxxxxx>
Add support for the SEV-SNP AP Creation NAE event. This allows SEV-SNP
guests to alter the register state of the APs on their own. This allows
the guest a way of simulating INIT-SIPI.
A new event, KVM_REQ_UPDATE_PROTECTED_GUEST_STATE, is created and used
so as to avoid updating the VMSA pointer while the vCPU is running.
For CREATE
The guest supplies the GPA of the VMSA to be used for the vCPU with
the specified APIC ID. The GPA is saved in the svm struct of the
target vCPU, the KVM_REQ_UPDATE_PROTECTED_GUEST_STATE event is added
to the vCPU and then the vCPU is kicked.
For CREATE_ON_INIT:
The guest supplies the GPA of the VMSA to be used for the vCPU with
the specified APIC ID the next time an INIT is performed. The GPA is
saved in the svm struct of the target vCPU.
For DESTROY:
The guest indicates it wishes to stop the vCPU. The GPA is cleared
from the svm struct, the KVM_REQ_UPDATE_PROTECTED_GUEST_STATE event is
added to vCPU and then the vCPU is kicked.
The KVM_REQ_UPDATE_PROTECTED_GUEST_STATE event handler will be invoked
as a result of the event or as a result of an INIT. The handler sets the
vCPU to the KVM_MP_STATE_UNINITIALIZED state, so that any errors will
leave the vCPU as not runnable. Any previous VMSA pages that were
installed as part of an SEV-SNP AP Creation NAE event are un-pinned. If
a new VMSA is to be installed, the VMSA guest page is pinned and set as
the VMSA in the vCPU VMCB and the vCPU state is set to
KVM_MP_STATE_RUNNABLE. If a new VMSA is not to be installed, the VMSA is
cleared in the vCPU VMCB and the vCPU state is left as
KVM_MP_STATE_UNINITIALIZED to prevent it from being run.
Signed-off-by: Tom Lendacky <thomas.lendacky@xxxxxxx>
Signed-off-by: Brijesh Singh <brijesh.singh@xxxxxxx>
Signed-off-by: Ashish Kalra <ashish.kalra@xxxxxxx>
[mdr: add handling for restrictedmem]
Signed-off-by: Michael Roth <michael.roth@xxxxxxx>
What is the intended boot sequence for SEV-SNP guests? FWIW with this
interface in place, guests will typically use in-guest VMSA pages to hold
secondary vcpu state. But that means we're now allocating 4kb of memory for
every vcpu that we create that will be for most of the guest's lifetime
superfluous.
Wouldn't it make more sense to have a model where we only allocate the VMSA
for the boot CPU and leave secondary allocation to the guest? We already
need firmware changes for SEV-SNP - may as well make this one more.
I don't think we'd necessarily need a firmware change. We could just
free original VMSA back to the hypervisor as soon as those APs come
online. The down-side to that versus deferring cleaning till guest
shutdown is there is some flushing activity (see:
sev_flush_encrypted_page()) that would now likely be occuring during
guest boot up where the overhead might be more noticeable. But for SNP
the host likely supports X86_FEATURE_SME_COHERENT so the overhead
probably isn't that bad.
Currently, OVMF code will perform a broadcast IPI to start all the APs
because it doesn't know the APIC IDs until they start for the first time.
Until the APIC IDs are known, the guest BSP can't create the VMSAs.
However, a new GHCB event is in plan to retrieve the APIC IDs for the
guest. Once that is in place, then you could create just a single VMSA for
the BSP and then allow the guest to create the remainder (the current OVMF
PoC patches to support an SVSM do this). The VMM would have to know that
the hypervisor and the firmware both support that, though. That could be
advertised as part of the GUID table of the firmware (in the case of OVMF)
and as a capability from KVM.
Thanks,
Tom
[...]
+
+static int sev_snp_ap_creation(struct vcpu_svm *svm)
+{
+ struct kvm_sev_info *sev = &to_kvm_svm(svm->vcpu.kvm)->sev_info;
+ struct kvm_vcpu *vcpu = &svm->vcpu;
+ struct kvm_vcpu *target_vcpu;
+ struct vcpu_svm *target_svm;
+ unsigned int request;
+ unsigned int apic_id;
+ bool kick;
+ int ret;
+
+ request = lower_32_bits(svm->vmcb->control.exit_info_1);
+ apic_id = upper_32_bits(svm->vmcb->control.exit_info_1);
+
+ /* Validate the APIC ID */
+ target_vcpu = kvm_get_vcpu_by_id(vcpu->kvm, apic_id);
Out of curiosity: The target CPU can be my own vCPU, right?
I don't think that would be the normal behavior, but maybe with some
care it's possible for a guest to do things that way. I haven't seen
anything strictly prohibiting this in the relevant specs.
+ if (!target_vcpu) {
+ vcpu_unimpl(vcpu, "vmgexit: invalid AP APIC ID [%#x] from guest\n",
+ apic_id);
+ return -EINVAL;
+ }
+
+ ret = 0;
+
+ target_svm = to_svm(target_vcpu);
+
+ /*
+ * The target vCPU is valid, so the vCPU will be kicked unless the
+ * request is for CREATE_ON_INIT. For any errors at this stage, the
+ * kick will place the vCPU in an non-runnable state.
+ */
+ kick = true;
+
+ mutex_lock(&target_svm->sev_es.snp_vmsa_mutex);
+
+ target_svm->sev_es.snp_vmsa_gpa = INVALID_PAGE;
+ target_svm->sev_es.snp_ap_create = true;
+
+ /* Interrupt injection mode shouldn't change for AP creation */
+ if (request < SVM_VMGEXIT_AP_DESTROY) {
+ u64 sev_features;
+
+ sev_features = vcpu->arch.regs[VCPU_REGS_RAX];
+ sev_features ^= sev->sev_features;
+ if (sev_features & SVM_SEV_FEAT_INT_INJ_MODES) {
+ vcpu_unimpl(vcpu, "vmgexit: invalid AP injection mode [%#lx] from guest\n",
+ vcpu->arch.regs[VCPU_REGS_RAX]);
+ ret = -EINVAL;
+ goto out;
+ }
+ }
+
+ switch (request) {
+ case SVM_VMGEXIT_AP_CREATE_ON_INIT:
+ kick = false;
+ fallthrough;
+ case SVM_VMGEXIT_AP_CREATE:
+ if (!page_address_valid(vcpu, svm->vmcb->control.exit_info_2)) {
+ vcpu_unimpl(vcpu, "vmgexit: invalid AP VMSA address [%#llx] from guest\n",
+ svm->vmcb->control.exit_info_2);
+ ret = -EINVAL;
+ goto out;
+ }
+
+ /*
+ * Malicious guest can RMPADJUST a large page into VMSA which
+ * will hit the SNP erratum where the CPU will incorrectly signal
+ * an RMP violation #PF if a hugepage collides with the RMP entry
+ * of VMSA page, reject the AP CREATE request if VMSA address from
+ * guest is 2M aligned.
This will break genuine current Linux kernels that just happen to allocate a
guest page, no? In fact, given enough vCPUs you're almost guaranteed to hit
an aligned structure somewhere. What is the guest supposed to do in that
situation?
The initial SNP support for guest kernels already made use of
snp_alloc_vmsa_page() to do the appropriate workaround to avoid allocating
2MB-aligned VMSA pages.
-Mike
Amazon Development Center Germany GmbH
Krausenstr. 38
10117 Berlin
Geschaeftsfuehrung: Christian Schlaeger, Jonathan Weiss
Eingetragen am Amtsgericht Charlottenburg unter HRB 149173 B
Sitz: Berlin
Ust-ID: DE 289 237 879
