From: Joerg Roedel <jroedel@xxxxxxx> Make sure segments are properly set up before setting up an IDT and doing anything that might cause a #VC exception. This is later needed for early exception handling. Signed-off-by: Joerg Roedel <jroedel@xxxxxxx> Reviewed-by: Kees Cook <keescook@xxxxxxxxxxxx> Link: https://lore.kernel.org/r/20200724160336.5435-33-joro@xxxxxxxxxx --- arch/x86/kernel/head_64.S | 52 +++++++++++++++++++-------------------- 1 file changed, 26 insertions(+), 26 deletions(-) diff --git a/arch/x86/kernel/head_64.S b/arch/x86/kernel/head_64.S index f958d4e4ee08..057c7bd3eeb6 100644 --- a/arch/x86/kernel/head_64.S +++ b/arch/x86/kernel/head_64.S @@ -174,6 +174,32 @@ SYM_CODE_START(secondary_startup_64) */ lgdt early_gdt_descr(%rip) + /* set up data segments */ + xorl %eax,%eax + movl %eax,%ds + movl %eax,%ss + movl %eax,%es + + /* + * We don't really need to load %fs or %gs, but load them anyway + * to kill any stale realmode selectors. This allows execution + * under VT hardware. + */ + movl %eax,%fs + movl %eax,%gs + + /* Set up %gs. + * + * The base of %gs always points to fixed_percpu_data. If the + * stack protector canary is enabled, it is located at %gs:40. + * Note that, on SMP, the boot cpu uses init data section until + * the per cpu areas are set up. + */ + movl $MSR_GS_BASE,%ecx + movl initial_gs(%rip),%eax + movl initial_gs+4(%rip),%edx + wrmsr + /* Check if nx is implemented */ movl $0x80000001, %eax cpuid @@ -201,32 +227,6 @@ SYM_CODE_START(secondary_startup_64) pushq $0 popfq - /* set up data segments */ - xorl %eax,%eax - movl %eax,%ds - movl %eax,%ss - movl %eax,%es - - /* - * We don't really need to load %fs or %gs, but load them anyway - * to kill any stale realmode selectors. This allows execution - * under VT hardware. - */ - movl %eax,%fs - movl %eax,%gs - - /* Set up %gs. - * - * The base of %gs always points to fixed_percpu_data. If the - * stack protector canary is enabled, it is located at %gs:40. - * Note that, on SMP, the boot cpu uses init data section until - * the per cpu areas are set up. - */ - movl $MSR_GS_BASE,%ecx - movl initial_gs(%rip),%eax - movl initial_gs+4(%rip),%edx - wrmsr - /* rsi is pointer to real mode structure with interesting info. pass it to C */ movq %rsi, %rdi -- 2.28.0
