On 10 May 2013 09:50, Mai Daftedar <mai.daftedar@xxxxxxxxx> wrote:
Hello,
I suggest for you to check out chapters 6.1, about bridge networking, and if you still have troubles then 6.4 MMC booting (image file should be less than 2 GB) from the KVM-on-ARM guide.
Regards.
To run the model shell i use the following:and I defined the following in the /etc/exports fileThanks Christopher for your reply. Please excuse my in-experience in thisThese are literally the semihosting commands I use (I define them in a params file):
motherboard.smsc_91c111.enabled=1
motherboard.hostbridge.userNetworking=1
cluster.cpu0.semihosting-cmd_line=--kernel uImage --dtb host-a15.dtb -- earlyprintk console=ttyAMA0 mem=2048M root=/dev/nfs nfsroot=192.168.0.45:/srv/nfsroot/ rw ip=dhcp
motherboard.pl011_uart0.out_file=/home/mai/ARM/somefile
motherboard.pl011_uart0.unbuffered_output=1
/srv/nfsroot 192.168.0.0/255.255.0.0(rw,sync,no_root_squash,no_subtree_check,insecure)
model_shell cadi_system_Linux-Release-GCC-4.6.so -f params /home/mai/ARM/boot-wrapper/linux-system-semi.axf
I read that there is another way to run this using an mmc image. Can you please advice.
Hello,
I suggest for you to check out chapters 6.1, about bridge networking, and if you still have troubles then 6.4 MMC booting (image file should be less than 2 GB) from the KVM-on-ARM guide.
Regards.
_______________________________________________ kvmarm mailing list kvmarm@xxxxxxxxxxxxxxxxxxxxx https://lists.cs.columbia.edu/cucslists/listinfo/kvmarm
