On Wed, Jun 17, 2020 at 11:59:10PM -0700, Nadav Amit wrote:
> > On Jun 17, 2020, at 10:08 PM, Andersen, John <john.s.andersen@xxxxxxxxx> wrote:
> >
> > On Wed, Jun 17, 2020 at 08:18:39PM -0700, Nadav Amit wrote:
> >>> On Jun 17, 2020, at 3:52 PM, Nadav Amit <nadav.amit@xxxxxxxxx> wrote:
> >>>
> >>>> On Jun 17, 2020, at 3:46 PM, John Andersen <john.s.andersen@xxxxxxxxx> wrote:
> >>>>
> >>>> Paravirutalized control register pinning adds MSRs guests can use to
> >>>> discover which bits in CR0/4 they may pin, and MSRs for activating
> >>>> pinning for any of those bits.
> >>>
> >>> [ sni[
> >>>
> >>>> +static void vmx_cr_pin_test_guest(void)
> >>>> +{
> >>>> + unsigned long i, cr0, cr4;
> >>>> +
> >>>> + /* Step 1. Skip feature detection to skip handling VMX_CPUID */
> >>>> + /* nop */
> >>>
> >>> I do not quite get this comment. Why do you skip checking whether the
> >>> feature is enabled? What happens if KVM/bare-metal/other-hypervisor that
> >>> runs this test does not support this feature?
> >>
> >> My bad, I was confused between the nested checks and the non-nested ones.
> >>
> >> Nevertheless, can we avoid situations in which
> >> rdmsr(MSR_KVM_CR0_PIN_ALLOWED) causes #GP when the feature is not
> >> implemented? Is there some protocol for detection that this feature is
> >> supported by the hypervisor, or do we need something like rdmsr_safe()?
> >
> > Ah, yes we can. By checking the CPUID for the feature bit. Thanks for pointing
> > this out, I was confused about this. I was operating under the assumption that
> > the unit tests assume the features in the latest kvm/next are present and
> > available when the unit tests are being run.
> >
> > I'm happy to add the check, but I haven't see anywhere else where a
> > KVM_FEATURE_ was checked for. Which is why it doesn't check in this patch. As
> > soon as I get an answer from you or anyone else as to if the unit tests assume
> > that the features in the latest kvm/next are present and available or not when
> > the unit tests are being run I'll modify if necessary.
>
> I would appreciate if you add a check of CPUID and not run the test if the
> feature is not supported.
>
> I run the tests on bare-metal (and other non-KVM environment) from time to
> time. Doing so allows to find bugs in tests due to wrong assumptions of KVM
> test developers. Liran runs the tests using QEMU/WHPX (non-KVM). So allowing
> the tests to run on non-KVM environments is important, at least for some of
> us, and benefits KVM as well.
>
> While I can disable this specific test using the test parameters, I prefer
> that the test will first check the environment they run on. Debugging test
> failures on bare-metal is hard enough without the paravirt stuff noise.
>
Great point! I'll add the check
