> On Jun 17, 2020, at 10:08 PM, Andersen, John <john.s.andersen@xxxxxxxxx> wrote:
>
> On Wed, Jun 17, 2020 at 08:18:39PM -0700, Nadav Amit wrote:
>>> On Jun 17, 2020, at 3:52 PM, Nadav Amit <nadav.amit@xxxxxxxxx> wrote:
>>>
>>>> On Jun 17, 2020, at 3:46 PM, John Andersen <john.s.andersen@xxxxxxxxx> wrote:
>>>>
>>>> Paravirutalized control register pinning adds MSRs guests can use to
>>>> discover which bits in CR0/4 they may pin, and MSRs for activating
>>>> pinning for any of those bits.
>>>
>>> [ sni[
>>>
>>>> +static void vmx_cr_pin_test_guest(void)
>>>> +{
>>>> + unsigned long i, cr0, cr4;
>>>> +
>>>> + /* Step 1. Skip feature detection to skip handling VMX_CPUID */
>>>> + /* nop */
>>>
>>> I do not quite get this comment. Why do you skip checking whether the
>>> feature is enabled? What happens if KVM/bare-metal/other-hypervisor that
>>> runs this test does not support this feature?
>>
>> My bad, I was confused between the nested checks and the non-nested ones.
>>
>> Nevertheless, can we avoid situations in which
>> rdmsr(MSR_KVM_CR0_PIN_ALLOWED) causes #GP when the feature is not
>> implemented? Is there some protocol for detection that this feature is
>> supported by the hypervisor, or do we need something like rdmsr_safe()?
>
> Ah, yes we can. By checking the CPUID for the feature bit. Thanks for pointing
> this out, I was confused about this. I was operating under the assumption that
> the unit tests assume the features in the latest kvm/next are present and
> available when the unit tests are being run.
>
> I'm happy to add the check, but I haven't see anywhere else where a
> KVM_FEATURE_ was checked for. Which is why it doesn't check in this patch. As
> soon as I get an answer from you or anyone else as to if the unit tests assume
> that the features in the latest kvm/next are present and available or not when
> the unit tests are being run I'll modify if necessary.
I would appreciate if you add a check of CPUID and not run the test if the
feature is not supported.
I run the tests on bare-metal (and other non-KVM environment) from time to
time. Doing so allows to find bugs in tests due to wrong assumptions of KVM
test developers. Liran runs the tests using QEMU/WHPX (non-KVM). So allowing
the tests to run on non-KVM environments is important, at least for some of
us, and benefits KVM as well.
While I can disable this specific test using the test parameters, I prefer
that the test will first check the environment they run on. Debugging test
failures on bare-metal is hard enough without the paravirt stuff noise.
