On bdw/hsw we have a separate psr dp aux registers to set up, but on bdw it's shared with the main dp aux thing. Which means any subsequent dp aux transaction will trample over it, and hence must be done beforehand. Also this means we can't do any dp aux transactions while PSR is active, or at least we must restore the old state. Probably need a psr disable/enable pair around dp aux transactions in general. Cc: Rodrigo Vivi <rodrigo.vivi@xxxxxxxxx> Cc: Sonika Jindal <sonika.jindal@xxxxxxxxx> Cc: Durgadoss R <durgadoss.r@xxxxxxxxx> Cc: "Pandiyan, Dhinakaran" <dhinakaran.pandiyan@xxxxxxxxx> Signed-off-by: Daniel Vetter <daniel.vetter@xxxxxxxxx> --- drivers/gpu/drm/i915/intel_psr.c | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-) diff --git a/drivers/gpu/drm/i915/intel_psr.c b/drivers/gpu/drm/i915/intel_psr.c index a088be65a267..87805078c8a3 100644 --- a/drivers/gpu/drm/i915/intel_psr.c +++ b/drivers/gpu/drm/i915/intel_psr.c @@ -197,6 +197,13 @@ static void hsw_psr_enable_sink(struct intel_dp *intel_dp) DP_SINK_DEVICE_AUX_FRAME_SYNC_CONF, DP_AUX_FRAME_SYNC_ENABLE); + if (dev_priv->psr.link_standby) + drm_dp_dpcd_writeb(&intel_dp->aux, DP_PSR_EN_CFG, + DP_PSR_ENABLE | DP_PSR_MAIN_LINK_ACTIVE); + else + drm_dp_dpcd_writeb(&intel_dp->aux, DP_PSR_EN_CFG, + DP_PSR_ENABLE); + aux_ctl_reg = psr_aux_ctl_reg(dev_priv, port); /* Setup AUX registers */ @@ -224,13 +231,6 @@ static void hsw_psr_enable_sink(struct intel_dp *intel_dp) (precharge << DP_AUX_CH_CTL_PRECHARGE_2US_SHIFT) | (aux_clock_divider << DP_AUX_CH_CTL_BIT_CLOCK_2X_SHIFT)); } - - if (dev_priv->psr.link_standby) - drm_dp_dpcd_writeb(&intel_dp->aux, DP_PSR_EN_CFG, - DP_PSR_ENABLE | DP_PSR_MAIN_LINK_ACTIVE); - else - drm_dp_dpcd_writeb(&intel_dp->aux, DP_PSR_EN_CFG, - DP_PSR_ENABLE); } static void vlv_psr_enable_source(struct intel_dp *intel_dp) -- 2.8.1 _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/intel-gfx
