With HDMI monitors we bumped up a case where the crtc clock rate caused a mismatch on state verification. This was due to assumption that the SW clock rate from PLL structure would match the calculated counterpart from HW. This is not necessarily always the case and therefore we would actually need to recalculate the clock rate from SW PLL parameters. Then these SW and HW crtc clock rates can be compared with each other. The patch recalculates the crtc clock rate for SW state based on SW PLL parameters and compares the crtc clock rate calculated from the parameters found from the HW. Signed-off-by: Mika Kahola <mika.kahola@xxxxxxxxx> --- drivers/gpu/drm/i915/display/intel_cx0_phy.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/gpu/drm/i915/display/intel_cx0_phy.c b/drivers/gpu/drm/i915/display/intel_cx0_phy.c index 8e3b13884bb8..89a195917179 100644 --- a/drivers/gpu/drm/i915/display/intel_cx0_phy.c +++ b/drivers/gpu/drm/i915/display/intel_cx0_phy.c @@ -3078,9 +3078,10 @@ static void intel_c20pll_state_verify(const struct intel_crtc_state *state, const struct intel_c20pll_state *mpll_sw_state = &state->dpll_hw_state.cx0pll.c20; bool sw_use_mpllb = intel_c20phy_use_mpllb(mpll_sw_state); bool hw_use_mpllb = intel_c20phy_use_mpllb(mpll_hw_state); + int clock = intel_c20pll_calc_port_clock(encoder, mpll_sw_state); int i; - I915_STATE_WARN(i915, mpll_hw_state->clock != mpll_sw_state->clock, + I915_STATE_WARN(i915, mpll_hw_state->clock != clock, "[CRTC:%d:%s] mismatch in C20: Register CLOCK (expected %d, found %d)", crtc->base.base.id, crtc->base.name, mpll_sw_state->clock, mpll_hw_state->clock); -- 2.34.1
