[PATCH] drm/i915: Add HSW CRT output readout support

[ville.syrjala@xxxxxxxxxxxxxxx]

From: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx>

Call intel_ddi_get_config() to get the pipe_bpp settings from
DDI.

The sync polarity settings from DDI are irrelevant for CRT
output, so override them with data from the ADPA registers.

Signed-off-by: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx>
---
 drivers/gpu/drm/i915/intel_crt.c | 33 ++++++++++++++++++++++++++++++++-
 drivers/gpu/drm/i915/intel_ddi.c |  4 ++--
 drivers/gpu/drm/i915/intel_drv.h |  2 ++
 3 files changed, 36 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_crt.c b/drivers/gpu/drm/i915/intel_crt.c
index f9a5f3d..ca7fd09 100644
--- a/drivers/gpu/drm/i915/intel_crt.c
+++ b/drivers/gpu/drm/i915/intel_crt.c
@@ -113,6 +113,34 @@ static void intel_crt_get_config(struct intel_encoder *encoder,
 	pipe_config->adjusted_mode.clock = dotclock;
 }
 
+static void hsw_crt_get_config(struct intel_encoder *encoder,
+			       struct intel_crtc_config *pipe_config)
+{
+	struct drm_i915_private *dev_priv = encoder->base.dev->dev_private;
+	struct intel_crt *crt = intel_encoder_to_crt(encoder);
+	u32 tmp, flags = 0;
+
+	intel_ddi_get_config(encoder, pipe_config);
+
+	tmp = I915_READ(crt->adpa_reg);
+
+	if (tmp & ADPA_HSYNC_ACTIVE_HIGH)
+		flags |= DRM_MODE_FLAG_PHSYNC;
+	else
+		flags |= DRM_MODE_FLAG_NHSYNC;
+
+	if (tmp & ADPA_VSYNC_ACTIVE_HIGH)
+		flags |= DRM_MODE_FLAG_PVSYNC;
+	else
+		flags |= DRM_MODE_FLAG_NVSYNC;
+
+	pipe_config->adjusted_mode.flags &= ~(DRM_MODE_FLAG_PHSYNC |
+					      DRM_MODE_FLAG_NHSYNC |
+					      DRM_MODE_FLAG_PVSYNC |
+					      DRM_MODE_FLAG_NVSYNC);
+	pipe_config->adjusted_mode.flags |= flags;
+}
+
 /* Note: The caller is required to filter out dpms modes not supported by the
  * platform. */
 static void intel_crt_set_dpms(struct intel_encoder *encoder, int mode)
@@ -804,7 +832,10 @@ void intel_crt_init(struct drm_device *dev)
 	crt->base.mode_set = intel_crt_mode_set;
 	crt->base.disable = intel_disable_crt;
 	crt->base.enable = intel_enable_crt;
-	crt->base.get_config = intel_crt_get_config;
+	if (IS_HASWELL(dev))
+		crt->base.get_config = hsw_crt_get_config;
+	else
+		crt->base.get_config = intel_crt_get_config;
 	if (I915_HAS_HOTPLUG(dev))
 		crt->base.hpd_pin = HPD_CRT;
 	if (HAS_DDI(dev))
diff --git a/drivers/gpu/drm/i915/intel_ddi.c b/drivers/gpu/drm/i915/intel_ddi.c
index 7e9fa53..a43ac3a 100644
--- a/drivers/gpu/drm/i915/intel_ddi.c
+++ b/drivers/gpu/drm/i915/intel_ddi.c
@@ -1269,8 +1269,8 @@ static void intel_ddi_hot_plug(struct intel_encoder *intel_encoder)
 		intel_dp_check_link_status(intel_dp);
 }
 
-static void intel_ddi_get_config(struct intel_encoder *encoder,
-				 struct intel_crtc_config *pipe_config)
+void intel_ddi_get_config(struct intel_encoder *encoder,
+			  struct intel_crtc_config *pipe_config)
 {
 	struct drm_i915_private *dev_priv = encoder->base.dev->dev_private;
 	struct intel_crtc *intel_crtc = to_intel_crtc(encoder->base.crtc);
diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h
index fb38ef1..e7fe5f1 100644
--- a/drivers/gpu/drm/i915/intel_drv.h
+++ b/drivers/gpu/drm/i915/intel_drv.h
@@ -828,5 +828,7 @@ extern void ironlake_check_encoder_dotclock(const struct intel_crtc_config *pipe
 
 extern bool intel_crtc_active(struct drm_crtc *crtc);
 extern void i915_disable_vga_mem(struct drm_device *dev);
+extern void intel_ddi_get_config(struct intel_encoder *encoder,
+				 struct intel_crtc_config *pipe_config);
 
 #endif /* __INTEL_DRV_H__ */
-- 
1.8.1.5

_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
http://lists.freedesktop.org/mailman/listinfo/intel-gfx