Hi,
On Tue, Oct 26, 2021 at 3:09 PM Lyude Paul <lyude@xxxxxxxxxx> wrote:
>
> As it turns out, apparently some machines will actually leave additional
> backlight functionality like dynamic backlight control on before the OS
> loads. Currently we don't take care to disable unsupported features when
> writing back the backlight mode, which can lead to some rather strange
> looking behavior when adjusting the backlight.
>
> So, let's fix this by ensuring we only keep supported features enabled for
> panel backlights - which should fix some of the issues we were seeing from
> this on fi-bdw-samus.
>
> Signed-off-by: Lyude Paul <lyude@xxxxxxxxxx>
> Fixes: 867cf9cd73c3 ("drm/dp: Extract i915's eDP backlight code into DRM helpers")
> ---
> drivers/gpu/drm/drm_dp_helper.c | 6 +++++-
> 1 file changed, 5 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/gpu/drm/drm_dp_helper.c b/drivers/gpu/drm/drm_dp_helper.c
> index ada0a1ff262d..8f2032a955cf 100644
> --- a/drivers/gpu/drm/drm_dp_helper.c
> +++ b/drivers/gpu/drm/drm_dp_helper.c
> @@ -3372,7 +3372,9 @@ int drm_edp_backlight_enable(struct drm_dp_aux *aux, const struct drm_edp_backli
> return ret < 0 ? ret : -EIO;
> }
>
> - new_dpcd_buf = dpcd_buf;
> + /* Disable any backlight functionality we don't support that might be on */
> + new_dpcd_buf = dpcd_buf & (DP_EDP_BACKLIGHT_CONTROL_MODE_MASK |
> + DP_EDP_BACKLIGHT_FREQ_AUX_SET_ENABLE);
My first thought when reading the above was: if we're masking so much
stuff out, why do we bother reading the old value back out at all?
I guess the two places you use the old value for are:
1. You avoid setting the "DP_EDP_PWMGEN_BIT_COUNT" if the backlight
was already configured for DPCD mode.
2. You avoid writing the register if you didn't change it.
I would actually argue that use #1 is probably a bug. If you're
worried about the firmware leaving the backlight configured in a
strange way, it could very well have left the backlight configured in
DPCD mode but set a different "bit count" than you want, right? Maybe
you should just always set the bit count?
Use #2 is fine, but does it buy you anything? Are writes to the DCPD
bus somehow more expensive than reads? ...or maybe you're expecting
that a display will glitch / act badly if you write the same value
that's already there?
So I guess my instinct here is that you should avoid reading all
together and just program the value you want.
-Doug
