On 26/05/2021 19:15, Matthew Brost wrote:
On Wed, May 26, 2021 at 10:25:13AM +0100, Tvrtko Ursulin wrote:
On 25/05/2021 18:01, Matthew Brost wrote:
On Tue, May 25, 2021 at 10:52:01AM +0100, Tvrtko Ursulin wrote:
On 06/05/2021 20:14, Matthew Brost wrote:
Disable semaphores when using GuC scheduling as semaphores are broken in
the current GuC firmware.
What is "current"? Given that the patch itself is like year and a half old.
Stale comment. Semaphore work with the firmware we just haven't enabled
them in the i915 with GuC submission as this an optimization and not
required for functionality.
How will the updated commit message look in terms of remaining reasons why
semaphores won't/can't be enabled?
Semaphores are an optimization and not required for basic GuC submission
to work properly. Disable until we have time to do the implementation to
enable semaphores and tune them for performance.
They were a nice performance win on some media workloads although granted a
lot of tweaking was required to find a good balance on when to use them and
when not to.
The same tweaking would have to be done for with GuC submission. Let's
get basic submission then tweak for performance.
I don't have fundamental complaints as longs as commit message is
improved and it is understood the absence of semaphores is extremely
likely to regress transcode performance tests. Latter probably doesn't
matter (for some definition of it) unless either there will be a
platform where both GuC and execlists can be supported, or there will be
two separate platforms similar in hw performance in theory, both
relevant to transcode customers, one using execlists and one using GuC.
Regards,
Tvrtko
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
