Link rate and lane count information are more easier and faster to check in i915_display_info than checking kernel logs for people not familiar with i915 in the following scenarios: * Debugging DP tunnel bandwidth usage in Thunderbolt driver. * In USB4 certification, it is a requirement to know which link rate used by monitor to prove that DP tunnel handle up to HBR3 * In PHY Compliance, when the connector propes are not mounted correctly, some display lanes will not show up in the DP Oscilloscope and will fail CTS. Just give the tester an easy way to identify where the problem is. Cc: Imre Deak <imre.deak@xxxxxxxxx> Cc: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx> CC: José Roberto de Souza <jose.souza@xxxxxxxxx> Signed-off-by: Khaled Almahallawy <khaled.almahallawy@xxxxxxxxx> --- drivers/gpu/drm/i915/display/intel_display_debugfs.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/gpu/drm/i915/display/intel_display_debugfs.c b/drivers/gpu/drm/i915/display/intel_display_debugfs.c index d62b18d5ecd8..c6161c1e87e9 100644 --- a/drivers/gpu/drm/i915/display/intel_display_debugfs.c +++ b/drivers/gpu/drm/i915/display/intel_display_debugfs.c @@ -990,9 +990,10 @@ static void intel_crtc_info(struct seq_file *m, struct intel_crtc *crtc) yesno(crtc_state->hw.active), DRM_MODE_ARG(&crtc_state->hw.adjusted_mode)); - seq_printf(m, "\tpipe src size=%dx%d, dither=%s, bpp=%d\n", + seq_printf(m, "\tpipe src size=%dx%d, dither=%s, bpp=%d, link rate = %d, lane count = %d\n", crtc_state->pipe_src_w, crtc_state->pipe_src_h, - yesno(crtc_state->dither), crtc_state->pipe_bpp); + yesno(crtc_state->dither), crtc_state->pipe_bpp, + crtc_state->port_clock, crtc_state->lane_count); intel_scaler_info(m, crtc); } -- 2.25.1 _______________________________________________ Intel-gfx mailing list Intel-gfx@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/intel-gfx
