On Fri, Dec 04, 2020 at 05:08:30PM -0800, Aditya Swarup wrote:
> Add changes for configuring DPLL for ADL-S
> - Reusing DG1 DPLL 2 & DPLL 3 for ADL-S
> - Extend CNL macro to choose DPLL_ENABLE
> for ADL-S.
> - Select CFGCR0 and CFGCR1 for ADL-S plls.
>
> On BSpec: 53720 PLL arrangement dig for adls:
> DPLL2 cfgcr is programmed using _ADLS_DPLL3_CFGCR(0/1)
> DPLL3 cfgcr is programmed using _ADLS_DPLL4_CFGCR(0/1)
53720 shows DPLL's 0/1/2/3 in the diagram but the registers are named as
DPLL 0/1/3/4 (no #2). I don't see anywhere on 53720 that it explicitly
gives the mapping you mention here, but on page 53723 I see a note:
Due to current BSpec filtering limitations, the DPLL4_CRCFG0/1
(164294h/164298h) are used to control the DPLL2.
Assuming that's correct, the patch below has the registers for the last
two DPLL's swapped.
...
> +
> +#define _ADLS_DPLL3_CFGCR1 0x1642C4
> +#define _ADLS_DPLL4_CFGCR1 0x164298
> +#define ADLS_DPLL_CFGCR1(pll) _MMIO_PLL3(pll, _TGL_DPLL0_CFGCR1, \
> + _TGL_DPLL1_CFGCR1, \
> + _ADLS_DPLL3_CFGCR1, \
> + _ADLS_DPLL4_CFGCR1)
I.e., this should be
#define ADLS_DPLL_CFGCR1(pll) _MMIO_PLL3(pll, _TGL_DPLL0_CFGCR1, \
_TGL_DPLL1_CFGCR1, \
_ADLS_DPLL4_CFGCR1, \
_ADLS_DPLL3_CFGCR1)
Given the strange spec naming, I think this calls for a comment in the
code as well to clarify that yes, we really do want 4 before 3 and that
there's no 2.
Matt
> +
> #define _DKL_PHY1_BASE 0x168000
> #define _DKL_PHY2_BASE 0x169000
> #define _DKL_PHY3_BASE 0x16A000
> --
> 2.27.0
>
--
Matt Roper
Graphics Software Engineer
VTT-OSGC Platform Enablement
Intel Corporation
(916) 356-2795
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
