On Wed, Mar 6, 2013 at 9:55 PM, Jesse Barnes <jbarnes at virtuousgeek.org> wrote:
> On Wed, 6 Mar 2013 20:05:59 +0100
> Daniel Vetter <daniel at ffwll.ch> wrote:
>
>> On Fri, Mar 01, 2013 at 01:14:31PM -0800, Jesse Barnes wrote:
>> > Allows us to detect eDP panels that may not have the hotplug pin wired up.
>> >
>> > Signed-off-by: Jesse Barnes <jbarnes at virtuousgeek.org>
>>
>> Historically the lid status is horribly broken which is why it's disabled
>> by default. What changed to now enable it unconditionally? Is this a
>> requirement on vlv?
>> -Daniel
>>
>> > ---
>> > drivers/gpu/drm/i915/intel_dp.c | 10 ++++++++++
>> > 1 file changed, 10 insertions(+)
>> >
>> > diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
>> > index 05e1000..c127cb7 100644
>> > --- a/drivers/gpu/drm/i915/intel_dp.c
>> > +++ b/drivers/gpu/drm/i915/intel_dp.c
>> > @@ -2413,6 +2413,16 @@ g4x_dp_detect(struct intel_dp *intel_dp)
>> > struct intel_digital_port *intel_dig_port = dp_to_dig_port(intel_dp);
>> > uint32_t bit;
>> >
>> > + /* Can't disconnect eDP, but you can close the lid... */
>> > + if (is_edp(intel_dp)) {
>> > + enum drm_connector_status status;
>> > +
>> > + status = intel_panel_detect(dev);
>> > + if (status == connector_status_unknown)
>> > + status = connector_status_connected;
>> > + return status;
>> > + }
>> > +
>
> Well this doesn't touch the panel_detect() stuff at all, where we have
> the hacks to avoid using _LID...
Oh right, patch looks good to me now ;-) Merget to dinq, thanks.
-Daniel
--
Daniel Vetter
Software Engineer, Intel Corporation
+41 (0) 79 365 57 48 - http://blog.ffwll.ch
