Yet according to pm spec pcode read/write operations
aren't necessary for HSW.
Signed-off-by: Rodrigo Vivi <rodrigo.vivi at gmail.com>
---
drivers/gpu/drm/i915/intel_pm.c | 26 --------------------------
1 file changed, 26 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c
index 322c562..761be6f 100644
--- a/drivers/gpu/drm/i915/intel_pm.c
+++ b/drivers/gpu/drm/i915/intel_pm.c
@@ -2749,18 +2749,6 @@ static void hsw_enable_rps(struct drm_device *dev)
GEN6_RP_UP_BUSY_AVG |
GEN7_RP_DOWN_IDLE_AVG);
- ret = sandybridge_pcode_write(dev_priv, GEN6_PCODE_WRITE_MIN_FREQ_TABLE, 0);
- if (!ret) {
- pcu_mbox = 0;
- ret = sandybridge_pcode_read(dev_priv, GEN6_READ_OC_PARAMS, &pcu_mbox);
- if (ret && pcu_mbox & (1<<31)) { /* OC supported */
- dev_priv->rps.max_delay = pcu_mbox & 0xff;
- DRM_DEBUG_DRIVER("overclocking supported, adjusting frequency max to %dMHz\n", pcu_mbox * 50);
- }
- } else {
- DRM_DEBUG_DRIVER("Failed to set the min frequency\n");
- }
-
gen6_set_rps(dev_priv->dev, (gt_perf_status & 0xff00) >> 8);
/* requires MSI enabled */
@@ -2772,20 +2760,6 @@ static void hsw_enable_rps(struct drm_device *dev)
/* enable all PM interrupts */
I915_WRITE(GEN6_PMINTRMSK, 0);
- rc6vids = 0;
- ret = sandybridge_pcode_read(dev_priv, GEN6_PCODE_READ_RC6VIDS, &rc6vids);
- if (IS_GEN6(dev) && ret) {
- DRM_DEBUG_DRIVER("Couldn't check for BIOS workaround\n");
- } else if (IS_GEN6(dev) && (GEN6_DECODE_RC6_VID(rc6vids & 0xff) < 450)) {
- DRM_DEBUG_DRIVER("You should update your BIOS. Correcting minimum rc6 voltage (%dmV->%dmV)\n",
- GEN6_DECODE_RC6_VID(rc6vids & 0xff), 450);
- rc6vids &= 0xffff00;
- rc6vids |= GEN6_ENCODE_RC6_VID(450);
- ret = sandybridge_pcode_write(dev_priv, GEN6_PCODE_WRITE_RC6VIDS, rc6vids);
- if (ret)
- DRM_ERROR("Couldn't fix incorrect rc6 voltage\n");
- }
-
gen6_gt_force_wake_put(dev_priv);
}
--
1.8.1.2
